2010 ford f 150 remote starter

Good info, Dan.  That's exactly the way I do them, just have to extend those wires a little to reach.  The SJB is in the passenger kick panel.  Don't think many 2010 F150's had 80 bit encryption.  I used a DEI 1100F on one and it worked fine.Soldering is fun!

Thanks, Yea I used the SJB to wire a DTIMAZDA door trigger interface on my Python 574, other than that I didn't do to much at the SJB. Yea the DEI 1100F's and the DEI PKFM's work great. I used to have a 1100F on my Python 990 and switched to a PKFM with my newer Python 574 mainly for D2D and less wiring. An XpressKit PKFM should also work on this F150 if it is not a newer 80bit, I didn't even think 2010 had 80-Bit keys, I thought that started in 2011-2012 Models.    Also tntscar if your bypass uses TX and RX wires, instead of a Ring around the PATS module, make sure they are not wired backwards, easy mistake to make, and ford likes to swap wire colors, match the connector wiring. Its a PATS3, CONNECTOR E.   Wiring: PIN 1 - Ignition, PIN 2 - Ground, PIN 3 - TX, PIN 4 - RX.