94 4runner astrostart guidance

Alright I now have the remote start turning the truck over but it will not start it. It flashes a code 4 the tach is hooked up. I've checked it 3 times now. The door lock still does nothing.

Alright if the key is set to the run position and I try to use the auto start it does nothing. However, if I use the auto start then while the engine is cranking over turn the key to the run position she fires right up and once I hit the brakes the module disables and flashes a code two like it should. Any thoughts?

why don't you post what you have hooked up then we can tell you what you need.

Can you post all the conections you made? You do get a crank right? Are you sure you picked both of your ign wires?No better feeling then getting a remote start to work right!

Absolutely H1 Red and RED / black is on white-constant 12v Orange is on ignition 1 BLACK / YELLOW Yellow is on accessory blue/red Green is on Parking lights green (+) Blue is on black starter wire H2 Brown is on blue/white in kick panel verified with test light that it's the lock Red is nowhere Blue is on blue / YELLOW in kick panel verified with test light that it's the lock (Lock unlock doesn't work) H3 Nothing is installed H6 Green is not connected BLACK/ red hood switch WHITE/ green is on GREEN / WHITE off brake switch Black is grounded BLACK/ green is connected to the diagnostic connector for tach H7 & H8 Nothing H9 Green is connected to GREEN/ red under the column ORANGE / white is not connected Orange is not connected

jpadj22 wrote: Can you post all the conections you made? You do get a crank right? Are you sure you picked both of your ign wires?

I do get crank. I only used ignition #1 not #2. Nothing on this sheet even indicates that it wants to be connected to ignition #2

You have to hook upboth ign wires from the 4 runner. I cant seem to find the instalation guide online but guessing the ur harness H3 should have a wire that csn be programed as your 2nd ign. Can you post a pic of level 5,6,7and 8 programing?No better feeling then getting a remote start to work right!

jpadj22 wrote: You have to hook upboth ign wires from the 4 runner. I cant seem to find the instalation guide online but guessing the ur harness H3 should have a wire that csn be programed as your 2nd ign. Can you post a pic of level 5,6,7and 8 programing?

I have a picture of the instal guide on the first page of the thread towards the bottom.

I have never done an astrostart but this is what i understand from this programing instructions... you need to program the WHITE/ blue from harness h3 to ignition.

set the dip switches #1 on #2 off #3on #4 off...then #5 off #6 off #7 on #8 on # 9 off

you need to prees on the break so the unit can memorize your setting. the led should flash.

remember that you will get a (-) ignition output to the WHITE/ blue wire  DO NOT CONNECT TO YOUR 2ND IGNITON. go to the section relays you need wire up one to convert polarity from a (-) to +. the wire coming from pin 87 will be your 2nd ign. 

No better feeling then getting a remote start to work right!