the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2013 mazda 5 factory alarm


Post ReplyPost New Topic
< Prev Topic Next Topic >
racingtoys 
Member - Posts: 37
Member spacespace
Joined: December 23, 2002
Location: United States
Posted: January 18, 2014 at 10:49 PM / IP Logged Link to Post Post Reply Quote racingtoys
HI
Im trying to create a custom home made alarm for a Mazda 5 does anyone have the wiring colors and location for the factory alarm system and remote start.
Thanks a lot
racingtoys 
Member - Posts: 37
Member spacespace
Joined: December 23, 2002
Location: United States
Posted: January 22, 2014 at 12:32 AM / IP Logged Link to Post Post Reply Quote racingtoys
Does anyone have this please
Thanks
chev104275 
Gold - Posts: 1,419
Gold spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: November 26, 2007
Location: Massachusetts, United States
Posted: January 22, 2014 at 5:45 AM / IP Logged Link to Post Post Reply Quote chev104275
DIRECTWIRE™ WIRING INFORMATION - MAZDA / MAZDA5 / 2013 / Remote Start
12volts blue/black (40A) + ignition switch, white 8 pin plug, pin 8
Starter blue/red + ignition switch, white 8 pin plug, pin 5
     
Ignition blue + ignition switch, white 8 pin plug, pin 1
      
Accessory BLACK/ red + ignition switch, white 8 pin plug, pin 6
Second Accessory BLACK/ white + ignition switch, white 8 pin plug, pin 7
Keysense blue + ignition switch, white 8 pin plug, pin 2
Power Lock blue -1000 ohms either kick or BCM behind glove box, white 24 pin plug (6), pin 14
Power Unlock (same as power lock) -
Lock Motor RED / blue to RED / yellow 5 wire either kick or BCM behind glove box, white 16 pin plug (5), pin 8
Unlock Motor RED / black 5 wire either kick or BCM behind glove box, white 16 pin plug (5), pin 7
Parking Lights+ blue/black + passenger kick, harness to rear
Parking Lights- BROWN / red - headlight sw or BCM behind glove box, blue 24 pin plug (2), pin 23
Hazards blue / YELLOW - hazard sw or BCM behind glove box, blue 24 pin plug (2), pin 7
Turn Signal(L) BLACK/ red + pass kick or BCM behind glove box, white 16 pin plug (5), pin 3
Turn Signal(R) RED / white + pass kick or BCM behind glove box, white 16 pin plug (5), pin 2
Reverse Light blue/white + pass kick or BCM behind glove box, gray 24 pin plug (1), pin 9
Door Trigger WHITE/ blue - N.C. either kick or BCM behind glove box, white 24 pin plug (6), pin 4
Dome Supervision yellow/black - pass kick or BCM behind glove box, white 16 pin plug (5), pin 15
Trunk/Hatch Pin RED / black - pass kick or BCM behind glove box, white 24 pin plug (6), pin 15
Hood Pin gray - N.C. BCM behind glove box, gray 24 pin plug (1), pin 17
Trunk/Hatch Release purple / YELLOW (rear handle switch) - pass kick or BCM behind glove box, white 24 pin plug (6), pin 8
    
Factory Alarm Arm blue/orange (driver door key lock) - either kick or BCM behind glove box, white 24 pin plug (6), pin 2
Factory Alarm Disarm lt. GREEN/ red (driver door key unlock) - either kick or BCM behind glove box, white 24 pin plug (6), pin 13
Disarm No Unlock (transponder and ignition)
     
Tachometer BLACK/ white, BLACK / YELLOW, BLACK/ blue, or blk/org ac any fuel injector, white 2 pin plug, pin 1
     
Brake Wire RED / yellow + brake switch, white 4 pin plug, pin 4
Parking Brake brown - pass kick or BCM behind glove box, blue 24 pin plug (2), pin 9
Horn Trigger PURPLE / white - horn switch or BCM behind glove box, blue 24 pin plug (2), pin 11
Memory Seat 1 N/A     
Memory Seat 2 N/A     
Memory Seat 3 N/A     
Interface Modules: Not Available
      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
If i Can't Install it    I Don't need it   Joe
racingtoys 
Member - Posts: 37
Member spacespace
Joined: December 23, 2002
Location: United States
Posted: January 22, 2014 at 9:26 AM / IP Logged Link to Post Post Reply Quote racingtoys
Thanks!!
gerardo30 
Member - Posts: 1
Member spacespace
Joined: May 31, 2009
Location: California, United States
Posted: March 17, 2015 at 11:55 PM / IP Logged Link to Post Post Reply Quote gerardo30
HI
I'm trying to Install the module for folding mirror for a Mazda 2 2012 does anyone have the wiring colors and location for the factory.
Thanks a lot

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, March 19, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer