remote starter not working right

You might want to look at some of the pictorials on this site to get an idea as to what you might be looking for. You could also follow the heavy gauge wires from the ignition switch back to the remote starter. An example of what you might be looking for: https://www.the12volt.com/installbay/forum_posts.asp?tid=136387When all else fails, Read the Instructions

Support the12volt.com Make a Donation

Wat does it mean if my theft light is blinking fastJeppenger

It means the remote start is no longer bypassing the keyIf i Can't Install it    I Don't need it   Joe

Ok thanks and is der anyway I can use another bypass module like da fortin key override all......Jeppenger

You might be able to reprogram the current bypass module. I would start by dropping the dash and finding out what you haveIf i Can't Install it    I Don't need it   Joe

I have a dei 555 bypass module and is it reprogrammableJeppenger

I'm assuming it's a 555u with a key inside. You can try taking 2 none cloned keys and reprogramming it. Use the first key and turn it to the on position wait till the anti theft light goes out, then within 5 seconds turn the first key off and put the second one in and turn it on, wait for the anti theft light to go out. Then once the light goes out turn the second key off and within 5 seconds remote start the truck. If it works the truck should start. If not you can try pulling the key out of the box and doing the same procedure as above except instead of remote starting the truck. Use the 3rd key and start the truck.If i Can't Install it    I Don't need it   Joe

No it doesn't have da key in it I think its da 555fw.where does da lil thing on da end go toJeppenger

The first downloadable link is the one you want. It's the install guide scroll down the page 555fw install guideIf i Can't Install it    I Don't need it   Joe

Chev104 thanks for everything I had to reprogram it thanks for da programming tip.........Jeppenger