Viper 5706v, 2010 Hyundai Elantra

There are pictorials on here and youtube videos covering remote starts. Maybe you can learn from them.

catback wrote: There are pictorials on here and youtube videos covering remote starts. Maybe you can learn from them.

please i searched this forum, youtube and the web, i couldn't find a case similar my mine please i need from you just to list the wires( viper without DBall2) that should be connected to my car. should i go to W2W ???

Very little will lay out putting a 5706v into a 2010 elantra down to every detail. But much can be learned about installing remote starts, the wires, and what they do by seeing how some are done. If you just want it put in and done, paying someone to do it for you is as easy as it gets. If you want to actually learn and/or feel self-accomplishment, again lots of pictorials and youtube videos that will show you many installations of viper units (which are all very similar). Even if it's not a viper unit, R/S units are fairly standard in what wires and functions they have so you can even learn from them. As to your question on what wires to hook up, I answered this in this thread some pages ago when you posted your highlighted diagram. Once you omit (take out) the dball2 from the installation there is no W2W or D2D, there is only hardwire. And yes you should hardwire because it's the only way I or DEI (manufacturer of the 5706 and the dball2) think it will ever work.

And I've already posted the hardwire directions for this vehicle to the Downloads/Manuals section. Just follow it.

Hello, Guys see the images below, and tell me what you think. are these wires all i need to hook up with my vehicle???

Yes but in your climate is the rear defogger needed? H2/9 Hood , H2/10 trunk and H2/12 TACH also required.

Thank you for your quick reply howie, i appreciate it 1- i didn't understand the H2/10 2- is there an option in the viper to control the AC ( Air Conditioner ) from Viper remote?, if yes , do i need other wires to hook ? 3- image updated

howei, the H2/13 also i couldn't understand should i connect it to Ground cause my vehicle is automatic transmission???

H2/10 to GREEN/ black driver kick, gray 39 pin plug, pin 11. Yes connect it to ground.

howie, i need some clarification to wires listed below please 1- H2/15 and H2/18 ? 2- H2/3 ? 3- H2/4 To ( Dome Supervision yellow - driver kick, gray 39 pin plug, pin 14 ) 4- H2/20 To ( Brake Wire black + driver kick, gray 39 pin plug, pin 34 ) OR ( Parking Brake blue - dash fuse box, rear, white 20 pin plug (C), pin 8 ) ?? 5- i think i need H2/5 (-) 200ma status output ? Thanks in Advance.