Trying To Install Viper 412V, 1999 Chevrolet Silverado

Trying to install a Viper 412V in a 1999 Chevy Silverado. The truck was owned by my father and he had a GM VSL 4200 from the dealer about 20+ years ago because the truck didn't come with a keyless entry system installed from the factory and is starting to crap out. I bought a Viper 412V Keyless Entry to replace the existing alarm system. I was told by Viper that this one works with most existing alarm systems. I have tried but I am at a lose on this one. H1/1 RED (+) 12V Constant Power Input [Red Wire Coming from existing harness interface (VSL 4200)] H1/2 BLUE (-) 200mA Second Unlock Output [NOT USED] H1/3 BLACK/WHITE-1 Input of Dome Light Supervision Relay #87 H1/4 BLACK/WHITE Output of Dome Light Supervision Relay #30 [Black/White Wire Coming from existing harness interface (VSL 4200)] H1/5 GREEN/BLACK Lock #30 Common Output [Green/Black Wire Coming from existing harness interface (VSL 4200)] H1/6 WHITE/BLACK Lock #87 Normally Closed [NOT USED] H1/7 VIOLET/BLACK Lock #87 Normally Open [Don't know where to connect] H1/8 BLUE/BLACK Unlock #30 Common (Output) [Blue/Black Wire Coming from existing harness interface (VSL 4200)] H1/9 VIOLET Unlock #87 Normally Open (Input) [Don't know where to connect] H1/10 WHITE (+/-) Parking Light Flash Output [White Wire Coming from existing harness interface (VSL 4200)] H1/11 BLACK Chassis Ground Input [Black Wire Coming from existing harness interface (VSL 4200)] H1/12 (-) Horn Honk Output [Brown Wire Coming from existing harness interface (VSL 4200)] H1/13 LT. GREEN/BLACK Factory Alarm Disable [NOT USED] H1/14 WHITE/BLUE (-) 200 mA Channel 3 Validity Output [NOT USED] H1/15 YELLOW (+) Switched Ignition Input (Accessory) [Yellow Wire Coming from existing harness interface (VSL 4200)] H1/16 ORANGE (-) 500 mA Ground When Armed Input [NOT USED] H1/17 BROWN/BLACK Unlock #87A Normally Closed [NOT USED] H1/18 RED/WHITE (-) Output of Channel 2 [NOT USED]Robert