the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2000 Ford Explorer Wiring Discrepancy


Post ReplyPost New Topic
< Prev Topic Next Topic >
mikegl71 
Member - Posts: 10
Member spacespace
Joined: August 29, 2003
Location: United States
Posted: August 29, 2003 at 6:54 PM / IP Logged  

While looking here for wiring colors chart for a remote starter for the 2000 Ford Explorer, I got two different charts that contradict each other ..  Can anyone help me decypher which is the correct chart? 

One chart says there is no IGN2 wire  - One says the IGN2 wire is Gray / YELLOW, AND the same Gray / YELLOW wire is ALSO the Accessory wire.  Can one wire serve as both IGN and Accessory?  Don't we normally seperate these so the heater turns on after the car is started?

Also, one chart says that the BLACK/ Green wire is the accessory, and the other chart says that the BLACK/ Green wire is IGN3 .. 

https://www.the12volt.com/wireinfo/volt.asp?Year=2000&Make=Ford&Model=Explorer&Table=Security

OR

https://www.the12volt.com/installbay/detail.asp?info=alarm&year=2000&make=Ford&model=Explorer&ID=17802&type=Alarm

Thank you ---

elrayodesinaloa 
Copper - Posts: 120
Copper spacespace
Joined: April 28, 2003
Location: United States
Posted: August 29, 2003 at 6:59 PM / IP Logged  
Test the wires using a DMM if you are unsure. Where ever you get information about car's wiring diagrams there might be differences because some cars tend to have diffrent wire colors (not often but it happens) and I think everyone should agree that you don't just hook up wires because someone told you, you need to identify, test, and carry on with the install. Good luck
10nesne1 
Silver - Posts: 284
Silver spacespace
Joined: June 19, 2002
Location: British Columbia, Canada
Posted: August 31, 2003 at 12:46 AM / IP Logged  
I agreed with Elray. You should test every wire and regardless what others tell you. Here is another wiring info for your reference.
Good luck
Ford » Explorer » 2000
ITEM WIRE COLOR POL LOCATION INFOTECH #
12 VOLTS yellow + ignition harness    
IGNITION 1 GREEN/ purple + ignition harness    
Two wires each at switch, both are common, only need to power 1 each during remote start.
STARTER 1 RED / lt. blue + ignition harness    
ACCESSORY 1 gray / YELLOW + ignition harness    
Two wires each at switch, both are common, only need to power 1 each during remote start.
ACCESSORY 2 BLACK/ green + ignition harness    
POWER LOCK pink / YELLOW - driver's kick panel    
POWER UNLOCK pink/green - driver's kick panel    
FACTORY ALARM ARM arms on lock       
Arms on lock only with door open. It is necessary to send a signal to door trigger as well as lock to arm factory alarm.
FACTORY ALARM DISARM dk. GREEN/ purple - driver's kick panel    
DISARM DEFEAT pink/orange    driver's kick panel    
You may also use the pink/green power unlock wire.
DOORLOCK MOTOR pink/black   driver's kick panel    
DOOR UNLOCK MOTOR RED / orange   driver's kick panel    
PARKLIGHTS POSITIVE PURPLE / white + driver's kick panel    
Also found to be WHITE/ black at the rear of the switch.
PARKLIGHTS NEGATIVE WHITE/ purple - driver's kick panel    
HEADLIGHT red / YELLOW + light switch    
BRAKE lt.green + driver's kick, brake switch    
DOOR PIN    -      
In the drivers door harness find yellow/black for the drivers door. In the drivers kick panel find lt. GREEN/ YELLOW for the drivers rear door. In the passengers kick panel find gray/red for the passenger front door, and pink/lt. blue for the passengers rear door. All four wires are negative trigger and must be diode isolated together. Refer to directfax document #1076 for wiring information.
HOOD PIN tan/lt.green - driver's kick panel    
TRUNK PIN WHITE/ purple - driver's kick panel    
DOMELIGHT SUPERVISION use door trigger       
TACH tan / YELLOW   pcm     
The PCM is located at the top of the firewall towards the passenger side, the tan / YELLOW tach wire is also found at the back of the instrument cluster.
VSS gray/black A/C pcm     
The PCM is located at the top of the firewall towards the passenger side, the tan / YELLOW tach wire is also found at the back of the instrument cluster.
WIPER wht & dk.blu/org + wiper motor or relay    
Also found yellow/white (-) at the firewall connector.
HORN yellow/lt. green - steering column    
ITEM NOTE INFOTECH #
Immobilizer Use DEI module 555F to over-ride during remote start.    
Special Note Some models of this vehicle are equipped with PATS (Passive Anti Theft System). Use DEI module 555F to over-ride during remote start.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, May 23, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer