2003 Mazda protege remote start

Can anyone help with a 2003 mazda protege will be very much appreciated!! oh yeah remote start! THank you

MAZDA PROTEGE 03 12 VOLT-BLACK IGNITION-BLUE STARTER-BLACK/ BLUE DOME-BLACK/ L BLUE    DRIVER KICK PANEL BELOW FUSE BOX PAK LAMP-L GREEN/ BLACK(+) BLACK CONN LEFT OF STEERING                                 COLUMN POWER LOCK-L GREEN/ RED SINGLE WIRE SYS.GROUND THRU 1K               OHM RESISTOR TO LOCK & 620 OHM TO UNLOCK.      UNLOCK-   LOCATED ABOVE KICK PANEL AT RELAYS. IGNITION 2-BLACK/ RED ACCESSORIES-BLACK/ WHITE BRAKE LIGHT-GREEN/ YELLOW(+) SWITCH ABOVE BRAKE PEDAL TACH-VIOLET/WHITE AT PCM PIN 48 OF 104 PIN CONNECTOR

What do you need help with on the Protege..be a little more specific.~The Rookie~

Rookie of the year that is...

Don't let the smoke out of your equiptment..it doesn't go back in.

I have the same car with a APS996C on, I can probably give you any info you need, just be a tad more specific about what you need.2005 Toyota Corolla S

    1.8L VVT-i I-4

Always double check your wires with a DMM!!!

Do Not Use A Test Light!!!

MECP Certified Installer!

Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

I have the same car. Could you tell me where exactly the Tach is located? Where's the PCM? I know that I can get the Tach from the Diagnostic connector located at the driver side rear corner of the engine compartment. I found that connector, but I don't know which pin it is. Seems an easier way to tap into the tach this way. And how do you test if you got the right wire? I heard with a voltmeter set to AC and the voltage should increase as you rev the engine? Thanks.