the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

wiring setup check please


Post ReplyPost New Topic
< Prev Topic Next Topic >
sictruck 
Member - Posts: 22
Member spacespace
Joined: May 11, 2004
Location: United States
Posted: July 12, 2004 at 4:57 PM / IP Logged  

can someone look over my wires please.  this is for a solaris alarm going into a 2001 s10 w/ manual trans. thanks

Alarm wires                                                                                                             RED-                                                                      battery                                  WHITE/ GREEN(starter +)                     keyside yellow wire ign. switch harness WHITE/ BLUE(starter +)                   starterside yellow wire ign. switch harness ORANGE(acc)                                                    brown from ign. switch harness GREY(heater ac)                                                not connected      WHITE/ BROWN(ignition +)                 keyside pink wire ign. switch harness GREEN/ BLUE(ignition +)                     coilside pink wire ign. switch harness                                                                    & to relay for E-brake                     BROWN(parking light)                                  parking light                       GREY / YELLOW(trunk input)                          not used                       BLUE/BLACK(heater relay)                            not used                      BLUE/WHITE(brake light)                                relay w/ E-brake cable BROWN / RED(interior light supply)                not used                                  GREY(door trigger)                                           triggers                   BLUE/ORANGE(- out when started)             not used                    WHITE/ BLACK(hood input)                              hood trigger                BLUE/GREEN(reverse light)                            not used                             BLACK/ GRAY(RPM input)                                 MSD tach wire       WHITE/ VIOLET(-pulse ot b4 remote start)   blue/black from 555L GRAY/ORANGE(door unlock)                          lock switch             VIOLET/WHITE(- pulse out after remote start) not used                GRAY/VIOLET(- ch. A out acc.)                             RED / white from 530T      GREEN(armed out - acc.)                                 orange from 530T  

530 T                                           

VIOLET(ground path)                                        chassis ground                  GREEN(motor down)                                        #1 window motor down        BLUE(motor up)                                                 #1 window motor up               RED(12V)                                                             battery                                   BLACK(ground)                                                  chassis ground    VIOLET/BLACK(ground)                                    same                     GREEN/ BLACK(motor down)                           #2 window down    BLUE/BLACK(motor up)                                    #2 window up                   BROWN(switch up)                                             #1 up                                    WHITE(switch down)                                          #1 down                     RED / WHITE(- aux. input)                                   grey/violet from alarm    ORANGE(-ground when armed)                      green from alarm                 GREY(- output during activation)                      not used              BROWN / BLACK(switch up)                               #2 switch               WHITE/ BLACK(switch down)                            #2 switch

555L

BLACK / YELLOW(output to BCM)              orange wire from ign. switch harn. YELLOW(ingition switch)                            same but other side of wire    BLACK(passlock ground)                              chassis ground           BLUE/BLACK(status input)                            WHITE/ violet from alarm            PINK(ignition input)                                           WHITE/ brown from alarm           RED(12v)                                                                battery

my remote start doesn't not work.  no crank from the engine. 

JWorm 
Platinum - Posts: 2,208
Platinum spacespace
Joined: December 11, 2002
Location: New Hampshire, United States
Posted: July 12, 2004 at 8:12 PM / IP Logged  
Wow....that didn't format right.
Looking quickly I noticed you connected the WHITE/ violet from the Solaris to the blue/black of the 555L. You should have used the blue/orange from the Solaris instead. The 555L needs to see ground the whole time the vehicle is remote started, not just a pulse before remote starting. Clean up the formatting, and I'll look over the rest.
How did you bypass the clutch?
sictruck 
Member - Posts: 22
Member spacespace
Joined: May 11, 2004
Location: United States
Posted: July 13, 2004 at 12:26 AM / IP Logged  

sorry i don't know what happened. 

try this

Alarm wires

WHITE/ green(starter +)---keyside ign. switch harness yellow wire

WHITE/ blue(starter +)---starterside ign. switch harness yellow wire

orange(accessory)---ign. switch harness brown wire

Gray(heater ac)---not used

WHITE/ brown(ignition +)---keyside ign. switch harness pink wire

GREEN/ blue(ignition +)---coilside ign. switch harness pink wire & to relay for E-brake

brown(parking light)---parking light

gray / YELLOW(trunk input)---not used

blue/black(heater relay)---not used

blue/white(brake light)---brake pedal & relay w/ E-brake

BROWN / red(interior light supply)---not used

gray(door trigger)---triggers

blue/orange(- out when started)---not used

WHITE/ black(hood input)---hood trigger

blue/green(reverse light)---not used

BLACK/ gray(rpm input)---MSD tach wire

WHITE/ violet(-pulse out b4 remotestart)---blue/black from 555L

gray/orange(door unlock)---door switch

gray/green(door lock)--- door switch

violet/white(-pulse out after remotestart)---not used

gray/violet(- ch. A out accessories)---RED / white from 530T

green(armed out - accessory)---orange from 530T

530T

violet, black, violet/black(ground)---all to chassis ground

green, blue(#1 motor)---both to #1 motor

red(12v)---battery

GREEN/ black, blue/black(#2 motor)---both to #2 motor

brown, white(#1 switch)---both to #1 switch

RED / white(-accessory input)---gray/violet from alarm

orange(- ground when armed)---green from alarm

gray(- output during activation)---not used

BROWN / black, WHITE/ black(#2 switch)---both to #2 switch

555L

BLACK / YELLOW(ouput to bcm)---thin orange wire from ign. switch harness

yellow(ignition switch)---thin orange wire from ign. switch harness ign. side

black(passlock ground)---chassis ground

blue/black(status input)---WHITE/ violet from alarm

pink(ignition input)---WHITE/ brown from alarm

red(12v)---battery

sictruck 
Member - Posts: 22
Member spacespace
Joined: May 11, 2004
Location: United States
Posted: July 14, 2004 at 11:52 PM / IP Logged  
anyone have suggestions about my wire.  cause i hooked up the wire like so and my truck would not remote start.  it turns everything, fuel pump, guages, etc. on but no crank from the starter. 
JWorm 
Platinum - Posts: 2,208
Platinum spacespace
Joined: December 11, 2002
Location: New Hampshire, United States
Posted: July 15, 2004 at 1:07 AM / IP Logged  
I already told you what you did wrong.
maglin 
Copper - Posts: 206
Copper spacespace
Joined: June 30, 2004
Location: United States
Posted: July 15, 2004 at 8:24 AM / IP Logged  

i'm faced by a intricate challenge myself, regarding my old 69 Opel GT.  i have to build prox switches that hook up to the hood pin switch circuit.

Basically, when the hood pin is open, it shuts down the device.  at the same time, if the prox switch on the transmission reads neutral, and the parking brake is engaged, then the remote started can actually turn over the car... otherwise, you hit your remote, and bam... the car takes off accorss the parking lot.  Amusing, but destructive.  heh.

Thats how i'm 'bypassing' the clutch, as it were.  Then again, i don't have a switch on that cluitch that disables engine starting unless its pressed down...  of course, with a relay or two, that would cease to be an issue as well.

~~Dan

www.ctdg.org/dan/hobby/opelindex.html

maglin 
Copper - Posts: 206
Copper spacespace
Joined: June 30, 2004
Location: United States
Posted: July 15, 2004 at 8:25 AM / IP Logged  

...

sictruck 
Member - Posts: 22
Member spacespace
Joined: May 11, 2004
Location: United States
Posted: July 17, 2004 at 12:14 AM / IP Logged  

Jworm thanks man but i did try to switch those wires and still nothing.  i think it has to do with my 2nd ignition wire.  i don't have it hooked up cause im not sure where it exactly connects to.  could this cause it? and where should i connect it?

auex 
Platinum - Posts: 5,041
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: December 23, 2002
Location: Arizona, United States
Posted: July 17, 2004 at 1:15 AM / IP Logged  
This should be the input to the 555l- "blue/orange(- out when started". The "WHITE/ violet" would be a factory disarm output. Also is this the wiring for the starter kill relay or for the remote start starter output?
"WHITE/ green(starter +)---keyside ign. switch harness yellow wire
WHITE/ blue(starter +)---starterside ign. switch harness yellow wire" Well according to the manual for a solaris this is correct.
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer