1998 Explorer & Compustar 2WSS-AS

Home / the12volt's Install Bay / Car Security and Convenience / 1998 Explorer & Compustar 2WSS-AS (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

darkowy

Member - Posts: 22

Joined: September 14, 2004

Location: United States

Posted: October 19, 2004 at 3:20 PM / IP Logged

What's the proper method of testing negative type door pin switch triggers? Do I connect (+) probe of DMM to (+)12V constant and (-) probe of DMM to the wire to be tested or (-) probe to the ground and (+) probe to the wire? I'm trying to diode isolate all door triggers but I'm having hard time confirming those wires.

My info shows:

yellow/black drivers door driver kick panel light GREEN/ YELLOW drivers rear door driver kick panel (N/A I have 2 door model) WHITE/ purple rear hatch driver kick panel gray/red passenger front door passenger kick panel pink/light blue passenger rear door passenger kick panel (N/A I have 2 door model)

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

1998 Explorer & Compustar 2WSS-AS

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.