Remote starter 97 explorer

Home / the12volt's Install Bay / Car Security and Convenience / Remote starter 97 explorer (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Reeceddogg

Copper - Posts: 329

Joined: September 23, 2002

Location: United States

Posted: February 25, 2005 at 8:34 PM / IP Logged

I installed the PHOENIX DIGITAL DELUXE from asian wolf PHOENIX DIGITAL DELUXEon a 97 explorer. everything works fine until you drive the car. The alarm will activate while driving! the only time it will does this is after the car has been remote started. any ideas?

boomer_106

Silver - Posts: 710

Joined: November 25, 2003

Location: United States

Posted: February 25, 2005 at 11:13 PM / IP Logged

Did you interface the OEM alarm disarm wire?

bretbowman

Copper - Posts: 156

Joined: February 17, 2005

Location: United States

Posted: February 26, 2005 at 5:54 AM / IP Logged

Boomer is right.. There should be some kind of "factory disarm" or "ignition out" wire that sends out a (-) signal when you press the remote start button. This signal (if properly wired into your factory alarm) will disarm it so that you can remote start the car without setting off the alarm.

If this wire is not wired to receive (-) signal when remote starting the alarm is supposed to go off because your factory alarm thinks that someone is hot wiring your car.

Good luck finding it... comb the internet for multiple wiring diagrams, one of them should have a "key sense" or "alarm disarm" wire (usually around the steering column or driver's kick panel).

2002 Toyota Sequoia Limited 2WD (Clifford G5 Avantguard 5 w/ 2 SmartWindows modules) - IT Engineer - NRA Life Member - LDS Return Missionary - Married for time AND ETERNITY - Eternally sealed family

natsys

Copper - Posts: 87

Joined: October 11, 2002

Location: United States

Posted: February 26, 2005 at 7:40 AM / IP Logged

I did a 97--getting the factory alarm to arm gave me fits. Sounds like you had no problem with it. The instructions given me below made the alarm disarm no problem. You must have a "factory disarm" feature (negative one second pulse) from your RS for this to work.

| 12V|yellow |+ |ignition harness |

| SPEED SENSE|gray/black |8 |PCM *6 |

Hope this helps.

-Rob

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Remote starter 97 explorer

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.