viper 791xv 97 Maxima

I installed an viper 791 on an 97 maxima today. Everything works fine except the remote start.  When I try to activate the remote it acts as if its going to work (everything turns on but dosnt crank or event attempt to crank, it does that 3x. )  1 time I left the key in the ingnition th to on slot and it started the car fine but it didn't sense that the car was started and tried to start the car 2 more times while it was already on. I know the nissan has 2 starter wires. Do you have to  run relay on 2nd starter wire for it to start or should the the car atleast attempt to start if everything else is wired correct? I think I was confused w/some of the wires

the Four wires that plug into the relay satellite beside the ribbon harness I didn't use any of them.

Ok so What the 4 wires beside the relay ribbon harness on the relay satellite, would I use the puple (-) on the starter relay? or don't use the wires @ all?

blue(-0) status output

Orange(-) 200ma 2nd accessory output

Purple (-) 200ma Starter output

Pink (-) 200ma 3rd Ignition output

Thx I'm going to try it and see if that takes care of the problem