05 Nissan Titan, ignition wires

What shouldi use then?TDP

Nissan Titan 2005

strip the wire about a half inch clean. carefully push a pick tool, or probe thru the wire, makes kind of a hole thru the wire. The wire to be conected you need about half an inch of stripped wire to feed thru the "hole" in the trucks wire. push it thru the "hole", then squeeze the hole closed, and wrap the rest of the wire "around" the trucks wire. Solder it, then tape it up good. make sure you pull all of the wires the same direction...it will look nice and neet when your done. You can use this "method" for any large or small guage wire....no t-taps. A good solder iron, or gun is needed, as well as knowing how to properly use it.

Just installed an alarm w/remote stat on my Titan SE and the suggestions from KarTuneMan sounds a little easier. I unplugged the harness to get about an extra half inch and used t-taps, and someone like me with big hands; it wasn't that easy, but was able to do it. Nissan didn't leave much wire to play with on the Titans.Electriqtion