Need alarm/remote install help Chevy Blazer

Hey guys. I am new to the 12volt but it looks like it can help me out a lot. Hopefully I can help you guys out a little here and there also.  I am getting ready to do an alarm/remote start install on a friends 95 chevy blazer.  I was wondering if any of you guys happen to have a wiring diagram for this car.  I have installed plenty of alarms before and the only real problem I run into is not knowing which wire to tap into to control the parking lights (getting them to flash). This will be a first with the remote start however.  Any suggestions, Thanks for your guys help. 

any idea what color this tach wire is I should be looking for.    Thanks for the quick reply.  Keep em coming guys!

white @ coil on top of engine

just for giggles, I have a 96 chevy blazer with the Viper 550 esp (remote start).  It's a lot easier then you think.........just make sure your connections are secure.....I found that the horn fit great on the passenger side right in front of the CPU........Some chevy's need by-pass modules, but I know mine did not........Another huge thing......If you take off the dash, the top section around the gages and radio, be sure to watch for the hazard switch.  I broke mine but got really lucky and replaced it for free, it's very easy to break but very hard and costly to replace....hope something in this long note helps.....good luckInstaller: A rare sub-human life form that survives on the thrill of loud sub-sonic frequencies played from a 12 volt source (AKA ~ Bass Mechanix)

make sure you tap into the right wires such as starter , acc and accesory wires . Jon

Installer/Help Technician

---coral springs florida---

mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.