Toyota Factory Keyless Entry w/Ignition

Home / the12volt's Install Bay / Car Security and Convenience / Toyota Factory Keyless Entry w/Ignition (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

toddc

Member - Posts: 15

Joined: November 30, 2002

Location: United States

Posted: December 01, 2002 at 1:39 PM / IP Logged

I just installed a remote start on my 2003 Toyota Matrix which uses the factory keyless entry to activate starting. Unfortunately, the factory keyless entry will not operate while the car is running. Does anyone know a way around this? The car does not have an OEM alarm, so I'm hoping its just a matter of disconnecting the ignition sense wire to the keyless entry module. Schematics and module location would be very helpful if anyone has them. TIA

-Todd

finnman925

Member - Posts: 19

Joined: December 03, 2002

Location: United States

Posted: December 03, 2002 at 4:04 PM / IP Logged

I'll look it up for you tomorrow

Brian

mxxmikexx

Silver - Posts: 796

Joined: September 18, 2002

Location: United States

Posted: December 03, 2002 at 5:55 PM / IP Logged

why dont you just interface the remote starter to operate the locks and be done with it?

djfearny2

Silver - Posts: 810

This member has made a donation to the12volt.com. Click here for more info.

Joined: September 23, 2002

Location: United States

Posted: December 03, 2002 at 6:18 PM / IP Logged

yea you can get a dei valet 551r and it has a remote and and keyless entry.

Jon

Installer/Help Technician

---coral springs florida---

mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.

toddc

Member - Posts: 15

Joined: November 30, 2002

Location: United States

Posted: December 03, 2002 at 6:57 PM / IP Logged

As I mentioned in my first post, I have a system that relies on use of the factory remotes to start the vehicle. In retrospect, I should have purchased a unit that does everything. I think I have found the location of the factory keyless enty module. Its located in the passenger side upper rear quarter panel, by the hatch. My brother works at a Pontiac dealership and was able to pull the location drawing from the Vibe. He also was able to get a wiring schematic, buts its pretty vague. It only shows five wires coming out of the module. Thoughts?

-Todd

diabloed

Copper - Posts: 133

Joined: August 25, 2002

Location: United States

Posted: December 03, 2002 at 10:50 PM / IP Logged

12volts	white & black	+	ignition harness
Starter	red	+	ignition harness
Second Starter	N/A
Ignition	BLACK/ white	+	ignition harness
Second Ignition	BLACK / YELLOW	+	ignition harness
Third Ignition	N/A
Accessory	blue/red	+	ignition harness
Second Accessory	N/A
Keysense	blue/black	-	ignition harness
Power Lock	green	-	passenger kick panel
Power Unlock	blue/black	-	passenger kick panel
Lock Motor	blue	5wi	driver kick, door harness
Unlock Motor	red	5wi	driver kick, door harness
Parking Lights+	green	+	driver kick panel
Parking Lights-	GREEN / WHITE	-	headlight switch
Hazards	yellow/black	-	hazard switch
Turn Signal(L)	GREEN/ red	-	steering column
Turn Signal(R)	GREEN/ orange	-	steering column
Reverse Light	RED / black	+	pin 11, conn. 3 @ PCM
Door Trigger	RED / yellow	-	driver kick panel
Dome Supervision	comes on with unlock
Trunk/Hatch Pin	common with door trigger
Hood Pin	N/A
Trunk/Hatch Release	blue/white	-	release switch on dash
Power Sliding Door	N/A
Factory Alarm Arm	arms with lock
Factory Alarm Disarm	disarms with unlock
Disarm No Unlock	use key sense
Tachometer	black	ac	pin 5, conn. 4 @ PCM
Wait to start	N/A
Brake Wire	GREEN / WHITE	+	brake pedal switch
Parking Brake	RED / black	-	parking brake switch
Horn Trigger	GREEN/ YELLOW	-	steering column

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Toyota Factory Keyless Entry w/Ignition

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.