door trigger, 91 crx

Home / the12volt's Install Bay / Car Security and Convenience / door trigger, 91 crx (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Copper - Posts: 137

This member has made a donation to the12volt.com. Click here for more info.

Joined: September 16, 2004

Location: United States

Posted: September 08, 2005 at 7:52 PM / IP Logged

alright, now I am having a problem with the door trigger, I have the green wire of my viper 791xv connected to my GREEN/ red wire of my 91 crx and nothing, arm the system with the door open and does not say door is open on remote or give error siren. Or open the door with the alarm set and does not trip the alarm. I did not have a bulb in the dome light so I went and got one out of my other car the bulb lit up when the doors were open so I am pretty sure the triggers are good, just wasn't working on the alarm. Any ideas???

mobile1

Silver - Posts: 479

Joined: February 23, 2004

Location: United States

Posted: September 09, 2005 at 9:33 AM / IP Logged

not the right GREEN/ red wire? did you test it with a multimeter.

saleengt

Copper - Posts: 73

Joined: December 10, 2002

Location: United States

Posted: September 09, 2005 at 4:46 PM / IP Logged

GREEN/ red on running board, try to pull the pin switch to make sure its the right wire if you cant find it

ringojam

Copper - Posts: 215

Joined: June 10, 2003

Location: Manitoba, Jamaica

Posted: September 09, 2005 at 6:00 PM / IP Logged

Go the drivers side pillar and pick up green w red wire this is a common wire to hondas

Copper - Posts: 137

Joined: September 16, 2004

Location: United States

Posted: September 10, 2005 at 6:14 PM / IP Logged

alright, I tested with a multimeter at the switch and got -5.92 volts when the door was open, and at the brain I got the same, should it be different? This is really starting to piss me off because the other triggers are woking fine hood and trunk. Bought a dome light thinking maybe if the circuit is not complete wont work but still not working.

Also the alarm does not reset the previous triggers that set off the alarm, like say I open the trunk and set off the alarm, if I start the car and arm and disarm the system still shows up the trunk was triggered. Any ideas?

gcorrea

Silver - Posts: 436

Joined: May 22, 2004

Location: United States

Posted: September 11, 2005 at 1:49 AM / IP Logged

tyhe right wire should read 12 volts doors closed and 0 volts when doors opened, if i remember correctly hondas have a GREEN/ red wire ajnd a GREEN/ red wire but it also has grey markings, like dots, along the wire. probe the wire for the correct one. what alarm do you have?

gcorrea

Copper - Posts: 137

Joined: September 16, 2004

Location: United States

Posted: September 11, 2005 at 5:21 PM / IP Logged

the alarm is a viper 791xv, I will measure the voltage again to see what is up. Any ideas why the alarm triggers are not resetting, I am going to try a new ground too. I don't know this should not be that hard!

Copper - Posts: 137

Joined: September 16, 2004

Location: United States

Posted: September 11, 2005 at 5:57 PM / IP Logged

ok, I tapped into the wrong wire, I am just going to find the frieking wire in the a pillar, also could the reason the triggers are not resetting be because the remote start harness is not hooked up? I am just going to hook everything up later and I'll see what happens, thanks for the info all.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

door trigger, 91 crx

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.