AVIC-N2 Problem

Home / the12volt's Install Bay / Mobile Video, GPS, and Navigation / AVIC-N2 Problem (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

w-r-g

Member - Posts: 1

Joined: October 17, 2005

Location: United States

Posted: October 17, 2005 at 8:48 PM / IP Logged

Have been using a Avic-N2 unit for a couple months with no problems and now the just powers on and the screen pops out and powers off in that position. Turn off the vehicle and the screen goes back in. Checked out power and everything to the unit and all is fine. Do not know what the next step is. Hate to have to send it back to Pioneer if there is a simple problem but I have checked out most everything and reset the unit and all wires are where they should be. Anyone had this problem or know what might be causeing it much appreciated.

Thanks

Back to Top

grandcherokee01

Member - Posts: 18

Joined: October 27, 2005

Location: United States

Posted: November 26, 2005 at 2:54 PM / IP Logged

Hey w-r-g,

I have seen a couple problems like this. Are you sure that the unit powers off or does the screen just go black. Either way it sounds like the the tape wiring in the back of the monitor. It goes bad easily and may need to be replaced. If you fold down the screen to a horizontal position on the back left where it connects to the main part of the unit is a copper colored tape. If it is bad it can make your screen just go black. Also if thats not the problem have you completed the bypass for navigation and dvd playing? If so the solder may be touching the metal plate nearby which is grounding out the unit.

Any questions p_gcustomerservice@yahoo.com

Rick

Jeep Grand Cherokee '01

Infinity Gold System

Pioneer AVIC-N2 w/ rear view camera and iPod Adapter

2 8x10 LCD Headrest Monitors

2 5x7 LCD Headrest Monitors

2 JL 10 W7's, 500\1 Mono AMPS

5 Farad C

Back to Top

Search for other posts by grandcherokee01

kenmci

Copper - Posts: 161

Joined: July 15, 2003

Location: United States

Posted: December 14, 2005 at 4:01 AM / IP Logged

If your screen is powering off, shutting down and turning off and staying out. I believe there is a setting on the deck that you need to enable to have the screen close when the power is turned off. I don't know why it is like this but some units are like that. Check your settings menus and make sure that it's not just some dumb setting.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

AVIC-N2 Problem

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.