Wiring for 2001 Audi A6

Anyone have the diagram for a 2001 Audi A6?

DIRECTWIRE™ WIRING INFORMATION - AUDI / A6 / 2001 / Remote Start 12volts red    +   ignition harness Starter RED / black    +   ignition harness Second Starter blue    +   ignition harness Ignition black    +   ignition harness Second Ignition           Third Ignition           Accessory yellow/black    +   ignition harness Second Accessory           Keysense           Power Lock GREEN/ blue    -   C3, pin 12, keyless modul Notes: Unlock requires a double pulse. Ignition locks will cause the door lock switch and the interior lights not to work while driving, be sure to turn it off. The keyless module is under the driver side floor mat in front of the seat. Power Unlock brn/yel or brn/gry    -   C3, pin 6, keyless module Notes: The keyless module is under the driver side floor mat in front of the seat. Unlock requires a double pulse. Ignition locks will cause the door lock switch and the interior lights not to work while driving, be sure to turn it off. Lock Motor           Unlock Motor           Parking Lights+        headlight switch Notes: Vehicles with DRL use GREEN/ gray at the switch, and must use relay to isolate the switch side to prevent backfeed to the ignition. Vehicles without DRL use GREEN/ black and GREEN/ red at the switch. Parking Lights-           Hazards           Turn Signal(L)           Turn Signal(R)           Reverse Light           Door Trigger      -   keyless module Notes: Drivers door trigger is GREEN/ YELLOW in Conn. 5, pin 1, front passenger door is RED / gray in C5, pin 10, left rear door is BLACK/ red in C5, pin 12, and right rear door is BLACK/ purple in C5, pin 14. The keyless module is under the driver side floor mat in front of the seat. Dome Supervision comes on with unlock        Trunk/Hatch Pin           Hood Pin gray/red    -   C3, pin 10, keyless modul Notes: The keyless module is under the driver side floor mat in front of the seat. Trunk/Hatch Release PURPLE / green    +   release switch Power Sliding Door           Factory Alarm Arm arms with lock        Factory Alarm Disarm disarms with unlock        Disarm No Unlock           Tachometer        ignition coils Notes: For tach use gray / YELLOW, GREEN / WHITE, or GREEN/ gray at the coil pack on the front of the motor. Wait to start           Brake Wire RED / black    +   brake pedal switch Parking Brake           Horn Trigger BLACK / YELLOW    +   horn relay, driver side dash Memory Seat 1           Memory Seat 2           Memory Seat 3           Interface Module: Category: Immobilizer Bypass Required: Yes Type: Transponder Part #: 556UW Alternate Part1 #: 555B Alternate Part2 #: 555U Alternate Part3 #: DesignTech 20402 Alternate Part4 #: DesignTech 29402 Notes: See DirectFax document 1056 for additional wiring information.        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.