05 honda accord, remote start

yes I am aware the the Remote does not work while car is running.  I am still a little confused on the 5 wirw set up. Let me try to clearify my delima....I am using a Add-on ( slave ) RS I need 1 or 2 (-) neg pulses within 3 secinds to iniaite the RS sequence. I chose the pass un lock door motor.  When I press the cars keyless ( engine off) 1X the drivers door ulocks, 2x the pass door unlocks, 3 times the pass door motor is hit a second time. That is why i need to find the pass door unlock motor wire.  I know how to use a relay to change the (+) puluse from the door lock to the (-) i need for the RS.

Any help please

Hello I am having trouble witha rs in a 2005 honda accord.  This system i am installing is a slave rs. It requires 1 or 2 neg pulses with 3 seconds as a trigger  to begin the strat sequence.  I have choosen to use the passanger unlock circut. I have located the lock motor wires in a 3 wire connector just behind the glove box. If I connect my trigger wire to the pink/blue wire (-) out put AND push the DOOR button the rs starts the car. but if I use the factory remote it does not work.  Also if the factory alarm in activate will starting the car via rs cause the alarm to trigger?  ( just in case if i use the lock wire/button on my factory remote.

Here is the link to the wiring diagram https://www.the12volt.com/installbay/forum_posts.asp?tid=52488

thank you

Have you tried pushing the Lock button the number of times for the R / S?

I have :

Where is the module located in the door?  Must I remove the door panel? Is this the only way to disarm the factory alarm? How about permanemtly?

Irnotslow