window module activation input

I am hooking up a window module to my prestige keyless entry. I want the windows to roll up when I lock the car with the keyless, but the module won't continue to run with a ground pulse activation input. It requires the ground remain on until the windows are all the way up. Am I going to have to add relays to provide a constant ground when the doors are locked?

Does you Keyless have Starter Kill??MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

No.

May have to use a Timer ...........  If you configure a Latched Relay, you would have to come up with a way to disconnect after the Windows are up........MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

Is there an orange wire coming off the brain?  This is the ground when armed wire, this will trigger the window module to roll up each time you arm it.

There is not an orange ground when armed output. I don't have an alarm,  just a keyless with remote start. I guess that's why it doesn't have this wire. I hooked the window module to the lock wire, and it works, except, as soon as the doors lock, the module stops running. The windows only go up about 4 inches. I have 3 of these modules, and they are all the same. These are the first ones I have seen like this. The ones I used before just required a single pulse to activate the module, and then it would continue rolling the windows up all the way.

i went ahead an ordered a dei pulse timer. Thanks for the help.