791xv trunk trigger on remote, input only?

hmmm. only gray should report hood

Obviously I have something wrong. I'll re-check everything again tomorrow. I'll be sure to let you and the forum know what I find. It might be an ID10T error (Idiot) : D . Thanks again for your help.

you need to set the p button on the remote to report what you want it to. its in the manual.

mobilecustoms wrote: you need to set the p button on the remote to report what you want it to. its in the manual.

I did that and it appears to work. I press the (P) button to get into Program Mode then I pressed the Aux button to cycle between Hood and Trunk and I eventually got both. When I trigger the hood it shows as Hood When I trigger the door is shows as door When I trigger the trunk it shows as Trunk + Hood I'm not sure why it is showing as Hood as well, but it works! Atleast I now know that anytime trunk is displayed it is because trunk was triggered. Thanks! I'll try rechecking my wiring too just to be safe

legend1011 wrote: mobilecustoms wrote: you need to set the p button on the remote to report what you want it to. its in the manual. I did that and it appears to work. I press the (P) button to get into Program Mode then I pressed the Aux button to cycle between Hood and Trunk and I eventually got both. When I trigger the hood it shows as Hood When I trigger the door is shows as door When I trigger the trunk it shows as Trunk + Hood I'm not sure why it is showing as Hood as well, but it works! Atleast I now know that anytime trunk is displayed it is because trunk was triggered. Thanks! I'll try rechecking my wiring too just to be safe

I think I answered my own question. Here was I did: I went back into Programming Mode (P) and instead of selecting both Hood and Trunk I only selected Trunk. It reports as it should!!!! I guess that this option is for zone 4 which is kind of wierd. Maybe they do that so you can customize what it actually monitors which makes since. I wish they would have defaulted it to trunk. Now when I trigger hood it shows Hood When I trigger trunk it shows trunk When I trigger door it shows door The option I set according to the manual: After entering programming mode (P) "->Sensor icon selection (hood/trunk) Use "AUX" to toggle display selections between hood only (1 beep), trunk only (2 beeps), or hood and trunk (3 beeps) on the LCD display. The installer will have set the remote up to correctly display the installation (hood pin only, trunk pin only, or hood and trunk pin installed.)" I wish they would have said that this was for the H1/7 Blue (-) Multiplex Input. That would have helped tremendously, but never the less THANKS GUYS FOR POSTING AND HELPING ME GET THIS SOLVED>. GREAT FORUM EXPERIENCE! Thanks