adding door lock switches

Home / the12volt's Install Bay / Car Security and Convenience / adding door lock switches (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

andyh24

Member - Posts: 9

Joined: August 03, 2007

Location: Tennessee, United States

Posted: August 06, 2007 at 5:49 PM / IP Logged

Also, do I just do the same wiring to the passenger's side switch?

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: August 07, 2007 at 1:01 PM / IP Logged

No you take the lock outputs to motor and drivers' door AND back to passenger door along with 12v+ (disconnect lead from alarm to pass. door) Then use the 2 output wires to ground terminals, output terminals 2 pass. door motor and live to centre tap.

You might have to change output leads around at switches in the worst case you will blow the fuse.

Sorry about forgetting to tell you!

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: August 07, 2007 at 1:17 PM / IP Logged

Yes, AFTER the fuse but when you say TAP I assume you mean solder join, not scotch locks or other similar rubbish!

andyh24

Member - Posts: 9

Joined: August 03, 2007

Location: Tennessee, United States

Posted: August 07, 2007 at 5:50 PM / IP Logged

Yeah, I'm going to solder all of my connections. I am little confused by how I am supposed wire both switches though. I guess I need to figure out what each pin does on the switch. Each of my switches have 5 pins and they are not labeled.

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: August 08, 2007 at 2:31 AM / IP Logged

This is where you learn how to use a DMM adding door lock switches - Page 2 -- posted image.

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

adding door lock switches

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.