diode isolate.

Home / the12volt's Install Bay / General Discussion / diode isolate. (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

patrickmac888

Member - Posts: 3

Joined: January 31, 2013

Location: Texas, United States

Posted: April 14, 2013 at 5:58 PM / IP Logged

Im confused on how to diode isolate 2 (+) parking light output wires. one coming from aftermarket alarm and one coming from remote starter. I also need to connect them on a SPDT relay. Thanks in advance

tonanzith

Gold - Posts: 601

This member consistently provides reliable information

Joined: July 18, 2008

Location: Washington, United States

Posted: April 14, 2013 at 8:14 PM / IP Logged

I need more specfics. What alarm/remote start. What vehicle. And typically a diode isn't needed if using a relay.

Gary Sather

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: April 16, 2013 at 12:02 AM / IP Logged

You don't have to. Just join making sure they polarity is the same, if the vehicle spec calls for NEG (-) make sure they're both neg, ditto for POS (+).

patrickmac888

Member - Posts: 3

Joined: January 31, 2013

Location: Texas, United States

Posted: April 16, 2013 at 7:12 PM / IP Logged

Thanks for response.

2007 Toyota Corolla CE

Alarm - Omega Excal-500

Remote - Bulldogsecurity RS83B with built in bypass module.

thanks again.

patrickmac888

Member - Posts: 3

Joined: January 31, 2013

Location: Texas, United States

Posted: April 16, 2013 at 7:17 PM / IP Logged

howie ll wrote:

You don't have to. Just join making sure they polarity is the same, if the vehicle spec calls for NEG (-) make sure they're both neg, ditto for POS (+).

Thanks for response. Do i need to tap in from the alarm or remote starter's output wire? or tap in to the SPDT relay's wire? Im just gonna use a squeeze tap connector.

One more thing, will it break if I use both the negative and positive parking light wires? right now im using the negative for the alarm.

thanks again

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: April 16, 2013 at 11:26 PM / IP Logged

Show us your circuit, I don't understand the question.

Squeeze tap?

Forget it; just wrong in so many ways.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

diode isolate.

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.