the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

interior led wiring issue


Post ReplyPost New Topic
< Prev Topic Next Topic >
cherrington 
Member - Posts: 1
Member spacespace
Joined: April 11, 2006
Location: United States
Posted: June 24, 2008 at 10:36 AM / IP Logged  
I have a 2003 Olds alero, that I added some led interior lighting too. The power for these was run off the center console lamp power wire.
The setup was fine for a couple years, and just recently the main power wire burnt itself up. I removed, everything that was possibly connected to it, and I still have the issue of the connection being shorted. 0 volts when its suppose to be 12, and a short when checked with a continuity meter. So its grounded somewhere, obviously. Just i don't know where.
I checked all the fuses, to which, the parking lamp fuse under the hood was blown. After replacing that, nothing changed. The center console cigarette lighter has no power, neither do either of the lamps.
What do those wires connect to? I can trace them up into the dash, and over to the fuse box, but they are solid (no breaks in the wire) the whole way. So if the fuse is still unbroken, where is the common connection that is shorting these?
I had these wired in that manner, so the led lights would kick on, when it got dark enough for the DRLs to turn off (turning on the headlights and interior lights) Is it possible I shorted out the light sensor up in the front of the dash?
KPierson 
Platinum - Posts: 3,527
Platinum spaceThis member consistently provides reliable informationspace
Joined: April 14, 2005
Location: Ohio, United States
Posted: June 24, 2008 at 1:24 PM / IP Logged  

When you replaced the parking light fuse did the parking lights start working again?

When tracing down shorts it helps to have an electrical diagram of the circuit you are working on - that way you can isolate branches.

One great method is the "divide and conquer" method that involves cutting the wires and metering both sides of the cut wire to ground.  Typically, one side of the wire will stay at ground and the other will go to open (not shorted).  You can then work towards isolating the short.

Be careful though, some 12vdc circuits in cars rest at ground when the car is off - so you may want to do all your metering with the key in the "ON" position.

Kevin Pierson

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, May 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer