2009 honda crv auto window roll up

I have recently put in a Viper 5901 with a DEI 529T window roll up module. Everything is working out fine expect for the drivers window. More then often once the window is rolled down you loose control and it winds back up and you are not able to control the window anymore until about an hour or if the the cars turned on and off again. All the other 3 windows work fine and i ruled out the fact that it is a bad module because the passenger side window works fine. I do not understand. the only thing different about the windows is that the driver side window is an Auto Roll up and down window from the dealer. You guys have any advice.

Did you wire the driver's side at the two wires going to the motor. Check the 529t orange GWA trigger wire. Is this grounding when going over bumps? Did you install the 529t in the driver's door, if so is it grounded to the window switch ground, fed back to a bolt in the car or a bolt in the door. The 3rd. option is unacceptable, re-wire.