the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

viper 5706v dome light on constantly


Post ReplyPost New Topic
< Prev Topic Next Topic >
marker227 
Member - Posts: 10
Member spacespace
Joined: March 29, 2013
Location: New Jersey, United States
Posted: July 12, 2014 at 7:27 AM / IP Logged  
Hey all, so I just had a brand new 5706V installed in my 2005 Dodge Neon SRT 4. Everything is fine, except my dome light stays on. The light is faintly lit. I really mean like the LED bulb is about 5% lit. Which is strange because the LED is only ON/OFF at full brightness. There is no dimmer.
Anyway, I haven't been able to do any serious troubleshooting yet. I was wondering if anyone had ideas on what could be causing this. The new installer said they didn't even tap into the dome light. They used an FL Can and they only tapped into the parking lights.
This also happened with my 5901 install. I don't remember what the previous installer did to correct the issue or why the light was on.
catback 
Silver - Posts: 703
Silver spacespace
Joined: August 13, 2002
Location: Canada
Posted: July 12, 2014 at 7:52 AM / IP Logged  
If it's on after the install and it wasn't before the install take it back to them and have them fix it (unless the install was free, then it's you get what you pay for :D). As for what's causing this, apparently a low current is being run through the dome light circuit.
linkarmy09 
Member - Posts: 49
Member spacespace
Joined: March 17, 2014
Location: Oklahoma, United States
Posted: July 18, 2014 at 2:34 PM / IP Logged  
LEDs on my old maxima on my dome light used to be always lit also like OP about 5%. I did have a viper 5106 alarm but it was before i installed the LEDs but i never worried about LEDs already draw very little power so since it was so dim never worreied about. Left car with out starting for days and never had an issue with battery draining.
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: July 18, 2014 at 5:35 PM / IP Logged  
LED lights drain very, very slowly when the power is removed.
That notwithstanding, follow Catback's advice.
marker227 
Member - Posts: 10
Member spacespace
Joined: March 29, 2013
Location: New Jersey, United States
Posted: July 26, 2014 at 3:24 PM / IP Logged  
I took it back to the place that installed it. They are completely stumped.
They pulled the power from the Viper unit and the dome light is still on. They are wondering if the light is staying on because I swapped the factory non-LED bulb with a LED bulb.
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: July 26, 2014 at 4:00 PM / IP Logged  
Previous car, 5904, LEDs post install, no problems.
Current car 5906, LEDs pre install, again no problems.
I suggest a bad door switch or a bad BCM.
pentavolvo 
Copper - Posts: 241
Copper spacespace
Joined: September 30, 2003
Location: United States
Posted: July 26, 2014 at 5:08 PM / IP Logged  
Seen it before may need a loading resistor
catback 
Silver - Posts: 703
Silver spacespace
Joined: August 13, 2002
Location: Canada
Posted: July 26, 2014 at 5:14 PM / IP Logged  
So both the 5901 and the 5706 have been installed in the same car? If so and the previous installer was able to fix the problem with the LED still installed and the issue reappeared after the new install then the evidence points to the installation causing the problem and not the fact it's an LED bulb.
My thoughts are the LED is getting a ground though something interfaced with the interior/dome lighting. LED's don't require much current, even a high impedance path to ground will get it to glow. There's more to say but I think it'd be too confusing, the above is sufficient enough.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer