elantra touring '11 dball2+prostart 2w

Hello fellow DYIers, I'm currently installing a DBALL2 + ProStart 6-button 2-way Remote Starter (from Canadian Tire) on my canadian '11 Elantra Touring (with immobilizer, but no alarm). For some reason, NOTHING is working. - The DBALL2 never flashes green during init. Depending on if I reset and/or reflash, it either: flashes red twice (CAN2 not detected, despite the fact that continuity tests work), or constant red. If constant red and I follow the type 3 module programming procedure by turning the key on the ON position and pressing the programming button 5 times, the LED will slowly flash red between 25-30 times and then stop flashing. - The Remote Starter does not respond to any command on the remote. Door locks don't work. DBALL2: It is flashed for my model/year, with D2D disabled and Smart OEM Alarm Control disabled. HSCAN High Tan/Black to Car Pin 6 on the OBDII HSCAN Low Tan to Car Pin 14 on the OBDII EMS Com Data Yellow and Yellow/Black to Car Pin 15 (Blue/Black), leading to the EMS COM connector EMS Com Data Orange / YELLOW and ORANGE / Black to same Car Blue/Black, cut wire NOT leading to the EMS COM connector +12V Red to Car Orange (40A) ignition switch, white 6 pin plug, pin 5 Ground Black to Car ground Prostart: 6 Pin Main Ignition Harness +12V Red to Car Orange (40A) ignition switch, white 6 pin plug, pin 5 Starter Purple to Car White ignition switch, white 6 pin plug, pin 1 +12V Red #2 to Car Orange (40A) ignition switch, white 6 pin plug, pin 5 Ignition Yellow to Car Blue ignition switch, white 6 pin plug, pin 6 Accessories Orange to Car Pink ignition switch, white 6 pin plug, pin 3 5th relay Green NOT USED 5-Pin Secondary Harness Ground Black to Car ground Tach input Purple to DBALL2 Tach output Violet/White Hood switch Gray to hood switch Brake switch input Orange to DBALL2 Brake status output Gray Parking light output Yellow to Car dash fuse box, rear, white 30 pin plug, pins 22 (Yellow) 12-Pin Accessories Harness Trunk output Blue NOT USED Lock output Brown to Car driver kick, gray 39 pin plug, pin 25 (Green) Unlock output Green to Car driver kick, gray 39 pin plug, pin 39 (Yellow) Arm output WHITE/ Brown NOT USED Disarm output WHITE/ Green NOT USED Positive door input Blue/White NOT USED Starter kill output WHITE/ Orange NOT USED Parking brake input Orange to Car parking brake (Blue) External Trigger Input Purple NOT USED Ground out when running White to DBALL2 GWR Blue/White Negative Door Input Gray to Car Left Front Door Trigger driver kick, gray 39 pin plug, pin 36 (Red) Glow plug input Yellow NOT USED 3-pin Harness/ Currently NOT USED (programmable outputs) The clutch is bypassed. When disconnecting/reconnecting the ProStart, I can hear 4 clicks, but not 5 clicks (learning the transmitter). Any idea? Thanks and regards.

Nobody?