Third Ignition

I need to power a 3rd Ignition, but the RS I am installing only has two outputs. Is there a relay diagram around here that shows me what I need to connect? I tries searching around here with no luck.

I think I may have found it, is this what I want to do? <"http://www.velocitymotorsport.com/images/install_notes/P2P.jpg" border="0">

What kind of r/s?Gary Kline

MECP Master Technician

Crimestopper RS 900 VI. I am already using the (-) output for the Passlock Bypass and I don't have any diodes on hand to split the output on that one.

A 1996 Blazer doesn't have a 3rd ignition. The pink and white wires are the only two ignition circuits. The orange 12 gauge wire should be treated as an accessory wire. It's main job is to run the heater circuit. The 12 brown wire is the acc. wire that runs the radio etc. and doesn't require power during remote start. If you still want to power something up you should diode isolate your bypass and a relay. If your bypass is powered by ignition, then wire terminal 85 to ground out when running and terminal 86 to ignition.sparky

iv seen the chev vans with a 3rd ignition,,,but i have always gotten away without hooking up the 3rd one, its not a main ignition.     Whats the vehicle??

It was for a 2000 Buick Lesabre. I used that diagram and tapped off of the 2nd Ignition, worked perfectly. Thanks for the help.