Grinding Starter

Home / the12volt's Install Bay / Car Security and Convenience / Grinding Starter (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Lubrano

Copper - Posts: 113

Joined: October 19, 2003

Posted: January 18, 2004 at 6:49 PM / IP Logged

I have been using an old car starter made by Designtech called the Autocommand. Everyone probally had one at one time, it was sold at Autozone and other local part suppliers. It still works great except I want to be able to prohibit the starter from engaging when the car is in auto start. My new system I installed in my other car has this feature but designtech did not put this feature in. When you get in the car after It has been started and turn the key too far the starter will engage. I want it to disable the starter untill I hit the brake and which then switches the car over to normall ingintion. If anyone has any ideas please post them.

Thank You

Salvatore

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: January 18, 2004 at 7:04 PM / IP Logged

can you post the wiring info for that unit...

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

jrilla

Gold - Posts: 1,498

This member has made a donation to the12volt.com. Click here for more info.

Joined: November 19, 2002

Location: North Dakota, United States

Posted: January 18, 2004 at 7:30 PM / IP Logged

Look at starter kill relays in the the relay section of this website. You need to cut the starter wire and install a relay. There is a (-) out when running wire on that unit you have but it will be called Ign 3 I believe. It is a (-) ignition wire that you need to go to pin 85 of the relay. Pin 86 goes to Ignition, Pin 30 goes to keyside of starter wire, and pin 87a goes to the starter side of the starter wire along with the starter output from the RS.

J Rilla

Owner/Installer

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Grinding Starter

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.