the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Popping trunk rolls up my windows!


Post ReplyPost New Topic
< Prev Topic Next Topic >
jasonmmathews 
Member - Posts: 8
Member spacespace
Joined: October 09, 2005
Posted: October 09, 2005 at 1:15 PM / IP Logged  

I have a Matrix RSX 3.5 with a 530T window module.

I cannot figure out why popping my trunk makes my windows roll up.

I have on the 530T:

(-) Auxillary (This vents/rolls down the windows whenh it sees a negative)

(-) Ground When Armed (This rolls the windows up when it sees a negative)

(-) Relay for 610T (To keep your sensors from triggering while the windows are rolling up. I'm not using this.)

So the Matrix RSX must be sending a (-) signal out on the Ground When Armed wire when I open the trunk... But why?

Thanks for your help!

rami_1r 
Member - Posts: 34
Member spacespace
Joined: August 05, 2005
Location: Israel
Posted: October 09, 2005 at 2:32 PM / IP Logged  
where you took the command (-) from?the alarm?
jasonmmathews 
Member - Posts: 8
Member spacespace
Joined: October 09, 2005
Posted: October 09, 2005 at 3:03 PM / IP Logged  

I get the signal from the Matrix' Harness 1/Wire 1 Orange Ground When Armed (-).

cntrylvr79 
Silver - Posts: 582
Silver spacespace
Joined: July 02, 2005
Location: United States
Posted: October 09, 2005 at 7:34 PM / IP Logged  

Try disconnecting the main harness from the brain of the alarm and check to see if you get continuity between the RED / white and the orange wires of that harness.  If you do then you got a short between the 2 somewhere.

Cause I'm So white and nerdy...
First Class Certi-fried installer
jasonmmathews 
Member - Posts: 8
Member spacespace
Joined: October 09, 2005
Posted: October 10, 2005 at 12:20 AM / IP Logged  
Thanks! I'll try pulling the harness and checking for a short.
jasonmmathews 
Member - Posts: 8
Member spacespace
Joined: October 09, 2005
Posted: October 16, 2005 at 1:58 PM / IP Logged  

Update:

It was a short of sorts. The tilt sensor triggers into the same zone as the trunk. The tilt sensor also had to be hooked up to ground when armed to learn the tilt position. 

For some reason a trigger on that zone caused the Tilt sensor to send a ground out on Ground when armed (which rolled up my windows).

So now the tilt isn't hooked up, but the 530T is working correctly now. Thanks for your help.


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer