ct 3300 on a pontiac gp 2002

I have the system wired properly, it starts and runs, Where do I find the Arm and Disarm wires? I was told by support that they are coming in from the door, I opened the boot, I do not have the BLACK/ red wires they have listed. They have ORANGE / Black as Disarm and RED / Black as Arm, Both at the Drivers kick panel. I have been under the driver side looking, I cannot see these wires. Any one know where they are?

I found another post that focuses on the 2000 GP. Can I follow this ? You will not have to use the ARM/DISARM wires seeing that the system arms and disarms with lock/unlock. The only problem you will have is that the OEM slarm will be armed when you lock the car and upon remote starting the vehicle the OEM alarm will engage. What you will need to do it to go to the lock/unlock motor wires an d not the switch. Here are the colors: LOCK MOTOR----------gray              |   |driver kick panel            UNLOCK MOTOR------tan |   |driver kick panel

up

DEI lists (as you listed in the first post): Factory Alarm Disarm      ORANGE / black       -       driver kick panel This would be in the harness that runs from the vehicle into the door. You may also be able to turn off the factory alarm by checking the owner's manual.Installer, IT support, and FFL. I need less hobbies.

Have you verified you have a factory alarm? On the gp's there is a control module right in the drivers kick, the ORANGE / black wire reisdes there. You will have to verify with a meter as I believe there are atleast  2 ORANGE / black going into the module.

Twelvoltz wrote: DEI lists (as you listed in the first post): Factory Alarm Disarm      ORANGE / black       -       driver kick panel This would be in the harness that runs from the vehicle into the door. You may also be able to turn off the factory alarm by checking the owner's manual.

This is your BEST solution....

I have a factory alarm, I really do not want to turn it off. I have a set of 2 BLACK/ orange wires going to the BCM one is the Drivers door lock switch unlock signal. The other is the BCM Program enable signal. The only BLACK/ Red wire is a Trunk Ajar signal.

If i follow that the ORANGE / Black wire will disarm the alarm, Where is the RED / Black wire to arm the system?

Would this work: I reprogram the alarm arm/disarm to mode 3: System will ARM when doors are locked from any door lock switch, while any door or lift gate is open and key is removed from ignition switch or while locking doors with key or remote transmitter. The system will disarm using the key or the remote transmitter. Wire the lock signal into LOCK MOTOR-gray . Then use the unlock wire on the starter to UNLOCK MOTOR-tan and the disarm into BCM ORANGE / Black Drivers door lock switch unlock signal. Would this be able to lock and unlock the car as well as arm/disarm the alarm?

If you wish to only unlock and lock the drivers door.