what software to use with vinyl cutter?

Home / the12volt's Install Bay / General Discussion / what software to use with vinyl cutter? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

crudeau

Copper - Posts: 150

Joined: August 25, 2003

Location: United States

Posted: August 09, 2004 at 9:06 AM / IP Logged

Hey guys,

Not what section to really put this in, but I just acquired an IoLine Super 88 vinyl machine. And I am trying to determine what to software to run it with. I know I can use like Corel draw 8 or illustrator 9 along with some bridge software. But I am unsure of where to get bridge software. I would really like to use something for free. be it freeware or something off kazza or limewire. I just don't want to shell out a couple hundred bucks until I am sure I want to use the machine and that it is all working. And i already have a p4 system that is ready to run it, just need some software to dump on it and I am good to go.

Thanks,

Chris

01xcab

Member - Posts: 3

Joined: July 11, 2004

Location: United States

Posted: August 09, 2004 at 6:52 PM / IP Logged

I dont think theres any bridgeware thats freeware.

if you had a Roland you could cut directly from Corel

I have one for sale if interested.

Not too many people using Iolines cant say if thats good or bad.I think theres a co cut version thats under $300.

Check with SummaGraphics whos licensed the Co Cut.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

what software to use with vinyl cutter?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.