joining two molds

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / joining two molds (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Ketel22

Silver - Posts: 976

Joined: August 23, 2003

Location: United States

Posted: October 10, 2003 at 3:50 PM / IP Logged

if i where to make two molds one for each side of a enclsure and joined them whould it have the same structral intregerity as if i made one mold and built onto it. also what would the best way to join them be.

Quad L Handyman services

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: October 10, 2003 at 4:38 PM / IP Logged

It would be easier to make a single mold with a divider than two separate molds and then trying to connect then afterwards. What is it that your trying to do ?

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

Ketel22

Silver - Posts: 976

Joined: August 23, 2003

Location: United States

Posted: October 10, 2003 at 5:34 PM / IP Logged

well if possible i want to take a fiberglass mold of my seat and join it with the mold ill have from the back of my truck and take the seat out and put in place the fiberglass "seat" that will house my subs.

Quad L Handyman services

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

joining two molds

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.