Protect LED intermittent

A budy of mine hooked his cap up in series one timer and caused a similar problem, check that out.Gavin

SWEDISH RICE!

Grounds maybe ???  How long has this been happening? Double check your grounds are secure at both ends, making good contact to bare metal.99 F-one fitty

Pioneer Premier H/U

Alpine EQ

Kicker 1200 amp

4 Kicker comp 10s

6 kicker SS65.2 components

Make sure your subs arn't presenting too low of an impedance load on your amp, like said above.

Thnaks for the response guys. First thing I'll check is the ground. I'm not running any subs just running two sets of kappa perfect components. I just finished the install today so this has been happening today only. Thanks again for the help I will try the suggestions posted here.

Input gain could also be too high.Support the12volt.com

Thnaks for the responses. The input gain is at it's lowest level, so I'm pretty sure that's not it. The speakers are Rated at 100 watts RMS 400 watt max and the amp is supposed to be able to put out 113 watts RMS x 4 @ 4 ohms. So there really shouldn't be a power shortage. Could it be a ground problem if I have no problem playing the music at a lower volume? Maybe I have a bad connection? I'll have to check it out tomorrow. Thanks for the responses guys.

From the manual • PROBLEM: No audio (PROTECT LED flashes every 4 seconds). CAUSE and SOLUTION: DC voltage on amplifier output. Amplifier may need service; see enclosed warranty card for service information. • PROBLEM: No audio (PROTECT LED is on). CAUSE and SOLUTION: Amplifier is overheated. Make sure amplifier cooling is not blocked at mounting location; verify that speaker-system impedance is within specified limits. • PROBLEM: No audio (PROTECT and POWER LEDs flash). CAUSE and SOLUTION: Voltage less than 9V on BATT+ connection. Check vehicle charging system. • PROBLEM: No audio (PROTECT LED is on). CAUSE and SOLUTION: Voltage greater than 16V or less than 8.5V on BATT+ connection. Check vehicle charging system. • PROBLEM: Distorted audio. CAUSE and SOLUTION: Input sensitivity is not set properly, or amplifier or source unit is defective. Check INPUT LEVEL setting, or check speaker wires for shorts or grounds. • PROBLEM: Distorted audio (PROTECT LED flashes). CAUSE and SOLUTION: Short circuit in speaker or wire. Remove speaker leads one at a time to locate shorted speaker or wire, then repair.4 cylinders and two tires

Answer: Get rid of the amp and get a JBL for the same money."I don't play games. I play Nakamichi and that for real yo" - Probably some japanese kid said this in the early 80's trying to sell stereo out of his trunk lol.