Door locks

Home / the12volt's Install Bay / Car Security and Convenience / Door locks (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

niterunr

Member - Posts: 4

Joined: March 01, 2003

Location: United States

Posted: March 12, 2003 at 1:38 AM / IP Logged

I have a 1997 ford taurus g i just recently put an avital avistart 330 in everything works fine but when you start the car normaly (not with remote ) the alarm is supose to lock the doors three seconds after it starts it doesnt instead if you leave the door open it will lock the doors after it starts

Any help would be greatly appreciated

1st Time Installer

Bnluis

Silver - Posts: 578

Joined: December 24, 2002

Location: New York, United States

Posted: March 12, 2003 at 8:58 AM / IP Logged

it sounds like you are using the wrong door trigger wire for your alarm? Have you tested it to see if door trigger works? let me know if it helps. Follow wiring colors to fix problem. If you are using the positive trigger for the alarm, make sure to connect to positive trigger of car, same goes for negative, but use only one not both.

Door locks -- posted image.

1997 ford taurus

DOOR TRIGGER|BLACK/ lt. blue |+ |under dash light *1

*1 Also found lt. GREEN/ orange (-) at headlight switch. BLACK/ orange at GEM (instrument fuse panel) will get all doors and hatch on wagon. Rests at ground through ignition, cut and diode isolate.

Luis

Sound Waves

Is up to the installer to test all wires with a DMM whenever possible.

niterunr

Member - Posts: 4

Joined: March 01, 2003

Location: United States

Posted: March 12, 2003 at 9:59 AM / IP Logged

i will try this and let you know thanks for the reply

niterunr

Member - Posts: 4

Joined: March 01, 2003

Location: United States

Posted: March 19, 2003 at 9:21 PM / IP Logged

thanks very much that was it i realy appreciate the help

Bnluis

Silver - Posts: 578

Joined: December 24, 2002

Location: New York, United States

Posted: March 20, 2003 at 12:11 PM / IP Logged

no problem Door locks -- posted image.

Luis

Sound Waves

Is up to the installer to test all wires with a DMM whenever possible.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Door locks

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.