the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

viper 5901, toyota tacoma


Post ReplyPost New Topic
< Prev Topic Next Topic >
jrat69 
Member - Posts: 22
Member spacespace
Joined: January 01, 2009
Location: Indiana, United States
Posted: October 13, 2009 at 3:44 PM / IP Logged  
2008 Toyota Tacoma. Several people have said I would need to use diodes when using the viper 5901 on door lock wires, the dome light wires (some even say a relay here) and on the keysense wire(goes to the module and the Fortin bypass). Other tell of their install and do not mention using any diodes, just a relay for the 2nd start. Anybody know the correct way?
ajstetler 
Copper - Posts: 94
Copper spacespace
Joined: October 31, 2008
Location: Illinois, United States
Posted: October 13, 2009 at 3:59 PM / IP Logged  
TACOMA       2005 -2009
   
PART       COLOR       LOCATION       DIAGRAM
12 VOLT CONSTANT       WHITE/ BLUE (+) and WHITE/ RED (+)       IGNITION SWITCH HARNESS      
STARTER       GREEN/ BLACK (+) See NOTE *1       IGNITION SWITCH HARNESS      
STARTER 2       BLACK/ WHITE (+) See NOTE *1       IGNITION SWITCH HARNESS      
IGNITION 1       BLACK/ RED (+)       IGNITION SWITCH HARNESS      
IGNITION 2       BLUE / YELLOW (+)       IGNITION SWITCH HARNESS      
IGNITION 3       N/A            
ACCESSORY /HEATER BLOWER 1       WHITE/ GREEN (+)       IGNITION SWITCH HARNESS      
ACCESSORY /HEATER BLOWER 2       N/A            
KEYSENSE       GREEN/ BLACK (-)       IGNITION SWITCH HARNESS      
PARKING LIGHTS ( - )       GREEN (-)       @ HEADLIGHT SWITCH or BCEU, PIN 13, See NOTE *2      
PARKING LIGHTS ( + )       GREEN (+)       @ FUSE BOX 13-Pin plug, Pin 10      
POWER LOCK       PURPLE (TYPE B) See NOTE *3       IN DRIVERS KICK PANEL, 10-Pin plug, Pin 4      
POWER UNLOCK       GREEN/ BLACK (TYPE B) (Requires Double Pulse)       IN DRIVERS KICK PANEL, 10-Pin plug, Pin 8      
LOCK MOTOR WIRE       BLUE/RED (+)       IN DRIVERS KICK PANEL, 12-PIN Plug, Pin 10      
DOOR TRIGGER       See NOTE *4       @ FUSE BOX       14301_TACOMA_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION       BLUE (-), Requires Part #775 Relay       @ FUSE BOX, BLACK 13-Pin plug, pin 9      
TRUNK RELEASE       N/A            
SLIDING POWER DOOR       N/A            
HORN       GREEN/ RED (-)       @ FUSE BOX, 18-PIN Plug, Pin 10      
TACH       BLACK/ WHITE       @ DATA LINK CONNECTOR,pin 9, See NOTE *5      
WAIT TO START LIGHT       N/A            
BRAKE       BLUE (+)       @ FUSE BOX, 11-PIN Plug, Pin 2      
FACTORY ALARM DISARM       DISARMS with KEYSENSE wire, See NOTE *6       @ IGNITION SWITCH HARNESS      
ANTI-THEFT       TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY See NOTE *7       TRANSPONDER @ IGNITION SWITCH TUMBLER
Big Al
jrat69 
Member - Posts: 22
Member spacespace
Joined: January 01, 2009
Location: Indiana, United States
Posted: October 13, 2009 at 4:16 PM / IP Logged  
This is the wiring list I have seen posted here, but it says see note 1,2,3,4,5,6,7, but I never see the notes posted.
Thanks
ajstetler 
Copper - Posts: 94
Copper spacespace
Joined: October 31, 2008
Location: Illinois, United States
Posted: October 13, 2009 at 5:31 PM / IP Logged  
OTE *1 this vehicle uses (2) STARTER/CRANK wires, when connecting to a Remote Starter you must connect BOTH STARTER/CRANK wires to the STARTER/CRANK wire from the Remote Starter.
NOTE *2 the BECU (Body Electronic Control Unit) is attached to the back of the FUSE BOX, with a single 26-Pin Plug.
NOTE *3 when testing the DOOR LOCK and UNLOCK wires, you must TEST these wires when turning the kEY in the DRIVERS DOOR KEY CYLINDER ONLY.
NOTE *4 the DRIVERS DOOR is a GREEN/ YELLOW (-) in the 18-pin plug, pin 7, the PASSENGER DOOR is a RED / BLACK (-) in a 22-pin plug, pin 8, the REAR DOORS are a PINK/BLACK (-) in an 18-pin plug pin 6, when connecting to an ALARM SYSTEM, use all (3) DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM
NOTE *5 the DATA LINK CONNECTOR is located under the DRIVERS SIDE of the DASH.
NOTE *6 THE KEYSENSE WIRE WILL DISARM THE VEHICLE WITHOUT UNLOCKING THE DOORS BY APPLYING A (-)NEGATIVE TO THIS WIRE DURING REMOTE STARTING.
NOTE *7 the TRANSPONDER ANTI-THEFT System is standard on all V-6 models.
Big Al
scorpo900 
Member - Posts: 18
Member spacespace
Joined: November 06, 2009
Location: Florida, United States
Posted: November 23, 2009 at 10:10 AM / IP Logged  
See how I installed this on my 2005 Tacoma:
http://www.toyotanation.com/forum/showthread.php?p=2991492#post2991492 http://www.toyotanation.com/forum/showthread.php?p=2991492#post2991492
Always test. When in doubt, read and study. If still in doubt, read some more. If that don't work, don't do it then or your burn everything... a Chef

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer