viper 5701 defrost in jeep liberty 2011

-------------------------------------------------------------------------------- Hi all! I have a Viper 5701 installed in my 2011 Jeep liberty, but the "remote start defrost" function was never hooked up. I was wondering if anyone knows how I could go about hooking this feature up so the truck's defrost will kick in when I remote start it (and it's below whatever the cutoff temp is)? The option is enabled on the Viper (I purchased a BitWriter so I could program the alarm without using the all-too-exciting "push the valet button and count the beeps" method) and I'm fairly familiar with the 5701 as I've reprogrammed it several times after I upgraded it with the antenna from a 5901 to increase the range) Just not sure exactly what to hook the "defroster" wire from the Viper up to. I have a "toggle" switch in the Jeep for the defrost, but I assume I would somehow need to involve a relay of some kind that will allow me to turn the defroster on from the Viper and still allow it to be turned on manually with the switch. Thanks everyone! -Greg P.S. Also, the temp sensor in the 5701 is way off - reads like 15-20 too high. I think I've heard that these are notoriously inaccurate but I just thought I'd check with ya'all

Omega shows it as - Rear Defrost     DK BLUE\WHITE (+ LATCHED)     DRIVER KICK Test it with a DMM first. The correct wire will show no voltage with the defroster off and +12v constant when you press the defroster button.   You will need a relay once you confirm you have the right wire to connect the wire from the Viper to the defrost wire. Relay setup - Pin 86 - 12v constant Pin 87 - 12v constant Pin 87a - no connection Pin 30 - defroster wire in the Jeep Pin 85 - trigger wire from Viper Make sure to set the defrost output to Latched in the Viper menu.

Thanks SO much! Time to dive in and get this going before the first ice storm :) -Greg