Window Control Module Wires

Home / the12volt's Install Bay / Car Security and Convenience / Window Control Module Wires (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

dlm4ut

Member - Posts: 1

Joined: June 06, 2003

Location: United States

Posted: July 23, 2003 at 4:48 AM / IP Logged

I just installed a Commando RS-560 Remote Start/Alarm in my 2002 Chevy Express Conversion Van. I also installed a 2-window control unit. It all appears to work fine. However, there was an additional wire on the 2-window control unit that I did not know what its purpose was. I believe it was label as "accessory". What is the purpose of this wire? Can it be use to control the window control unit or is providing some feedback on what the window control unit is doing.

Fullthrottle

Copper - Posts: 101

Joined: December 03, 2002

Location: United States

Posted: July 23, 2003 at 10:43 AM / IP Logged

I believe that is a (-) 200ma output which can control other things. I used mine to by-pass my audio sensor during operation. It is supposed to last for 5 seconds after the module is done.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Window Control Module Wires

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.