PRO9232S installation Chevrolet Venture

Hi Guys,

I need instructions on how to install an AUDIOVOX PRO9232S to a 2003 Chevrolet Venture.I already have the wiring information for the VAN but i dont know specifically whichwires to tap into; (example: ARM/DISARM - should i tap directly to the door actuators or do i use theARM/DISARM output of the keyless entry module.) Preferably if somebody could tell me which specific wires from the Venture Van i will use to connect the wires described in the PRO9232S installation diagram. - arm, disarm#1, disarm#2, door switch trigger, ignition, +12V, GND, etc.

SecurityBattery           RED       (+)  IGNITION SWITCH HARNESSIgnition          PINK      (+)  IGNITION SWITCH HARNESSStarter01         YELLOW    (+)  IGNITION SWITCH HARNESSParkingLights     BROWN     (+)  AT VEHICLE LIGHT SWITCHRemote StartBattery           RED       (+)  IGNITION SWITCH HARNESSIgnition          PINK      (+)  IGNITION SWITCH HARNESSIgnition02        WHITE     (+)  IGNITION SWITCH HARNESSAccessory01       ORANGE    (+)  IGNITION SWITCH HARNESSStarter01         YELLOW    (+)  IGNITION SWITCH HARNESSAntiTheftType     PASSKEY IIIAntiTheftSystem	  AN RF SIGNAL ACTIVATED SYSTEMKeySense          LIGHT GREEN (-)  IGNITION SWITCH HARNESSTach              WHITE     (-)  LARGE HARNESS ON PASSENGER SIDE OF ENGINEParkingLights     BROWN     (+)  AT VEHICLE LIGHT SWITCHBrakeLights       WHITE     (+)  AT SWITCH ABOVE BRAKE PEDAL ReverseLights     LIGHT GREEN (+)  IGNITION SWITCH HARNESSDoorlocks / WindowPowerUnLock       ORANGE / BLACK (-)  IN HARNESS IN DRIVERS KICKPANELPowerLock         RED / BLACK (-)  IN HARNESS IN DRIVERS KICKPANELDriverDoorMotor01 TAN       (+)DriverDoorMotor02 GRAY      (+)  IN HARNESS IN DRIVERS KICKPANELConvenienceHeadLights        YELLOW    (+)  AT VEHICLE LIGHT SWITCHLowSpeedWipers    PINK      (+)  AT VEHICLE WIPER SWITCHTrunkRelease      BLUE      (-)  IN HARNESS IN PASSENGER KICKPANEL

the alarm has two DISARM inputs (DISARM#1 and DISARM#2), and one ARM input.  Which of of the van wiring mentioned above should i use; As i see there are more than one options;

Doorlocks / Window

Also, if i use the power lock/unlock mentioned above, would the existing DRIVER DOOR PANEL LOCK/UNLOCK SWITCH disarm the alarm ?

thanks.

Hi,

I also would like to get info on which wires to use for the door triggers - DRIVER, PASSENGER, SLIDING, TRUNK. As i see,there are a lot of possibilities to tap, i cant seem to determine which of these wires to use.

thanks