mannix/2000 accord door sensor/dome light

Home / the12volt's Install Bay / Car Security and Convenience / mannix/2000 accord door sensor/dome light (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

sgtjnelson

Member - Posts: 2

Joined: April 25, 2004

Location: United States

Posted: April 25, 2004 at 9:29 PM / IP Logged

i have a 2000 v6 accord 4 dr lx. recently purchased mannix remote start car alarm. im having trouble with completing the circuit correctly for the door sensors and dome light. as of now when alarm is armed the door on the lcd pager flashes and the siren sounds shortly after. the alarm seems to not recognize that the door is secured. also the srs light on instrument panel stays lit. can anyone help me please...all replies are welcome...thank you in advance

raydawg357

Silver - Posts: 769

Joined: June 17, 2003

Location: United States

Posted: April 26, 2004 at 8:05 AM / IP Logged

Your door pin is in the passenger side fuse box: BLACK/ white (-)

HONDA, ACCORD, 2000, Door Trigger

In a green 4 pin connector.

If you already have this wire tapped, check your door pins and make sure they are all good. Also, check to make sure your hood pin switch is adjusted correctly.

Do it right the first time

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: April 26, 2004 at 9:44 AM / IP Logged

SRS light is because of an ignition wire not being powered up properly when remote started. You will need to reset this error from the dealership or manually. Make sure that you used the correct door trigger input wire on the alarm harness. Most systems come with 2 door input wires, one for (+) type systems and one for (-) type systems, in this case you should have used the (-) input wire for the Accord.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

sgtjnelson

Member - Posts: 2

Joined: April 25, 2004

Location: United States

Posted: April 26, 2004 at 7:48 PM / IP Logged

do you think that the srs light is on because i took out the drivers seat and had to disconnect a connector that was part of the srs to do that.

also with this BLACK/ white wire ...do i cut in half from fuse box and run one end to 30 on the relay and the other to 87a...if so which end goes to which

i appreciate your guys help...it was much needed...thank you

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

mannix/2000 accord door sensor/dome light

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.