Valet 561R install

I am kind of new to the DEI product so your help is greatly appeaciated. What wire on this unit is a (-) ground while running? I need to hook up a TB-TOYDL which requires this signal from the remote starter. Also I am hooking up the 555U as well. I know that the Red is +12 and the blue is status. What wire on this RS can be used for this? All this stuff is going into a 05 toyota highlander. Thanks in advance. My guess is that the 555U goes to the pink (-) third ign turn on and the ground while running goes to the blue stsus output wire. These wires are from the 4-pin satellite harness diagramMECP certified (If it really means anything)

Jeremy

Dont ya just HATE DEI....the blue "status" wire is your GWR.....

actually its quite simple... any DEI installer can tell you  status=GWR      heck, a trained chimp could write it on a blackboard....Kevin Gerry

Certified Electronics Technician

MECP First Class Installer

Owner/Installer

Classic Car Audio

since 1979

blue / white in the same plug as your brake wire is a 2nd status outputKevin Gerry

Certified Electronics Technician

MECP First Class Installer

Owner/Installer

Classic Car Audio

since 1979

Thanks for the info. That was fast!!MECP certified (If it really means anything)

Jeremy

The second status/ blue/white isn't too reliable as a GWR.   I usually grab the pink in the wee 4 pin -ve out harness if I need additional GWR that is isolated from the main GWR (blue in the same plug).   You needed a second start as well, so you are also using the purple in the same plug. Gus Wherever I go, that is where I end up......