99 suburban, alarm/remote start

I have installed a commando 40/40 remote start, alarm, remote door locks etc. from Asianwolf It works great. I then installed roll-up modules which when I lock the car they work great. OK so the remote window roll-up activation is from the Armed output (-). When I remote start the car the windows roll-up about an inch and then the engine starts, the problem is that about 5 seconds later the starter motor re-engages and grinds on the already runnning engine. Any ideas, I undid the windows (armed output from the alarm) and it works fine?? Have I used the wrong activation for the windows? Any ideas why it would affect the car? I know that when the car starts a signal is send through this armed output to the Passlock 2 bypass but that should not cause the starter motor to re-engage would it? Any help would be great.

You may need to put a Relay on the Armed Output wire to supply a stronger Ground to the devices that you have hooked to it.MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.