2002 malibu keyless entry via 456a module

Home / the12volt's Install Bay / Car Security and Convenience / 2002 malibu keyless entry via 456a module (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

diesmart

Member - Posts: 4

Joined: November 16, 2005

Posted: February 07, 2006 at 8:23 PM / IP Logged

I have a 2002 Malibu non ls. I purchased a keyless entry remote start and alarm system, As well as the moduales for the door locks and the passlock system that i was told i needed. I have the keyless entry installed and working fine as well as the alarm however i can not figure out how and where to connect the door lock module a directed 456-a. has anyone here done this install before i can use all the help i can get i have spent at least 2 days on this and am getting very frustrated. the alarm manafacturer is aftermarket generation if that helps

mo12v

Platinum - Nominee - Posts: 2,748

This member consistently provides reliable information

Joined: September 30, 2003

Location: Afghanistan

Posted: February 07, 2006 at 8:43 PM / IP Logged

diesmart wrote:

I have the keyless entry installed and working fine as well as the alarm however i can not figure out how and where to connect the door lock module a directed 456-a.

If the Keyless is working, then you don't need the 456A......

Or do you mean you have the Keyless Installed and the door locks do not function?

Don't Learn from Others Mistakes

You Might Be the One That Knows.

diesmart

Member - Posts: 4

Joined: November 16, 2005

Posted: February 07, 2006 at 8:51 PM / IP Logged

sorry i have the remote start installed not the keyless

mo12v

Platinum - Nominee - Posts: 2,748

Joined: September 30, 2003

Location: Afghanistan

Posted: February 07, 2006 at 8:55 PM / IP Logged

RED = 12 volt Constant

BLACK = GROUND

GRAY / Black = Dome Light Output from your Alarm

BLUE = Negative Output while Running from your Alarm

GREEN = Negative Door Output

VIOLET = DATA Bus Output to Violet wire at OBDII Connector

Door Locks:

BLUE = Negative 1st Door Unlock from your Alarm

BLUE / White = Negative 2nd Door Unlock from your Alarm

GREEN = Negative Lock from your Alarm

Don't Learn from Others Mistakes

You Might Be the One That Knows.

diesmart

Member - Posts: 4

Joined: November 16, 2005

Posted: February 07, 2006 at 8:59 PM / IP Logged

Thanks ill try it

diesmart

Member - Posts: 4

Joined: November 16, 2005

Posted: February 07, 2006 at 9:30 PM / IP Logged

Do you have a aireing diagram for this car? 2002 malibu non LS

another-kelly

Silver - Posts: 618

Joined: July 11, 2004

Location: United States

Posted: February 07, 2006 at 11:10 PM / IP Logged

CHEVROLET / MALIBU / 2002 / Remote Start

12volts	red	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Starter	yellow	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Second Starter
Ignition	pink	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Second Ignition	dk. green	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Third Ignition
Accessory	orange	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Second Accessory	brown	+	ignition harness
Notes: Remove the radio, without unplugging it, to access the ignition harness.
Keysense
Power Lock	white	-	dkp in a black plug
Notes: Lock requires a negative trigger, and unlock requires a negative trigger through a 1,500 ohm resistor. Must use relays. Must close doors to lock with a single pulse.
Power Unlock	same wire
Lock Motor	gray		drivers kick panel
Unlock Motor	tan		drivers kick panel
Parking Lights+	brown		passenger kick or column
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger		-
Notes: The lt. GREEN/ black is located in the drivers kick and catches only the drivers door. The lt. blue is located in the harness coming from the drivers running board going under the drivers seat and it catches all other doors. Use both door trigger wires and diode isolate each. On the 2 door the lt.blue is in the passenger kick.
Dome Supervision	white	-	dash light or column
Trunk/Hatch Pin	ORANGE / black	-	trunk light
Hood Pin
Trunk/Hatch Release	BLACK/ white	+	drivers kick panel
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer	PURPLE / white		ignition coil or ECM
Notes: The ECM is located under the left side of the dash to the left of the column.
Wait to start
Brake Wire	lt. blue	+	at the switch
Parking Brake
Horn Trigger	black	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Interface Module:	Category: Immobilizer Bypass	Required: Yes	Type: Passlock II
Part #: 556LW
Alternate Part1 #: 555LW
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes:
Interface Module:	Category: Door Lock Interface	Required: Yes	Type: Multiplex
Part #: 456LW

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2002 malibu keyless entry via 456a module

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.