791xv

Home / the12volt's Install Bay / Car Security and Convenience / 791xv (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

mobilecustoms

Silver - Posts: 397

Joined: November 04, 2005

Posted: February 11, 2006 at 7:09 PM / IP Logged

on my viper 791xv, if i pull off the battery, and then reconnect, the alarm does not trigger. I thought it is supposed to go off when it is reconnected because it lost power. Is there a setting that could be off?

swamprat323

Gold - Posts: 1,335

Joined: September 22, 2002

Location: Florida, United States

Posted: February 11, 2006 at 7:14 PM / IP Logged

no the alarms stay in the last state it was when power was remove.

mobilecustoms

Silver - Posts: 397

Joined: November 04, 2005

Posted: February 11, 2006 at 7:15 PM / IP Logged

im surprised, the ford powercode r/s alarm i had triigered when you put power back on even if it was disarmed before pulling power.

swamprat323

Gold - Posts: 1,335

Joined: September 22, 2002

Location: Florida, United States

Posted: February 11, 2006 at 7:29 PM / IP Logged

a lot of alarm companys do that i dont liek it, change out the battery and the alarm goes off, i like how the DEI ones are.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

791xv

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.