2002 Subaru Forester Alarm Upgrade?

If you test the wires in this plug and there is change while you have the DMM on the wire, then you should be able to use it for the keyless entry. I found some more information about the 2002 Forester for you concerning the door locks. The wire to the switch seems to change when it goes to the motor. From what this wiring schematics says the switch wire is not the same as the motor wire to lock and unlock the doors.

• LOCK MOTOR: LIGHT GREEN/ BLACK
• UNLOCK MOTOR: BLUE/WHITE

Both wires are located at the KEYLESS MODULE and in the door. If you can , please scan the wiring page of the Guardian model 911-800 and email it to me and I will see if I can help figure out the wiring that is needed. Email me at this address: velocity@valleycable.com and if the above wires are correct, then you don't have to email me the file.

Good Luck and post your results.

If the wires that are on this 18 pin connector tests accordingly to the wires that you will need to incorporate the Guardian alarm, you should be able to use them. Make sure you use a DMM to confirm what the wiring diagram says and verify the wire by testing it's circuit. You can fax me the diagram at 1-204-822-1266 anytime and I'll reply back to you when I reveice the information.