the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

02 jeep liberty trunk release


Post ReplyPost New Topic
< Prev Topic Next Topic >
f16freek 
Member - Posts: 2
Member spacespace
Joined: November 07, 2007
Location: Virginia, United States
Posted: November 07, 2007 at 6:32 AM / IP Logged  
Hey guys,
   I've been lurking for a while now and finally decided to register so I could post here. I've been installing a remote-start/alarm on my 02 Jeep Liberty and can't figure out how to hook up the trunk release to open the rear glass. I found the "ORANGE / PINK flip-up release switch (-)" wire, but it shows 12 volts constantly. I can't figure out what exactly triggers it to open the trunk. I'm assuming that you don't just dump it to ground through a resistor like you do with the door locks because nobody has mentioned anything about using a resistor to trigger it. I'm completely at a loss and would appreciate your help.
Thanks a bunch,
Andrew
tedmond 
Gold - Posts: 4,610
Gold spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: January 06, 2007
Location: Ontario, Canada
Posted: November 07, 2007 at 6:52 AM / IP Logged  

hey man, if you go to your trunk and check out the trunk solenoid, ther should be 2 wires. there are 2 types to trigger. negative or postive

negative trigger. When one wire shows constant 12v and a ground is applied to pop the trunk.

postive trigger. when one wire shows constant ground and a 12v signal is applied to pop the trunk.

connect the negaive trunk relase on your alarm or RS to the ORANGE / pink wire at the BCM next to the fusebox. There is a gray plug. look for that ORANGE / pink and probe it so see if there is a ground when the switch is activated.

f16freek 
Member - Posts: 2
Member spacespace
Joined: November 07, 2007
Location: Virginia, United States
Posted: November 07, 2007 at 8:30 AM / IP Logged  
Thanks for the quick response! I'll give that a shot when I get back dug into it. I've gotta work all week :X so it'll prob be this weekend.
Thanks again!!
KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: November 07, 2007 at 8:34 AM / IP Logged  
ORANGE / black in harness above the OBD2 plug. It's a (POS)+ trigger. 12 volts triggered to this wire WILL pop the hatch!

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer