Wire Diagram for '98 Galant

Hey I need a wire diagram for a 98 mit. galant, i'm installing a magnum auto security and i'm kinda not sure what i'm doing so any help would be great too thanks a lot

DIRECTWIRE™ WIRING INFORMATION - MITSUBISHI / GALANT / 1998 / Security 12volts red (larger of 2)   +   ignition harness Starter BLACK / YELLOW   +   ignition harness Ignition BLACK/ white   +   ignition harness Power Lock GREEN / WHITE   -   brown & blue plug be- Power Unlock RED / green   -    hind driver dash speaker Lock Motor blue/black   5wi driver window switch in door Unlock Motor blue/red   5wi driver window switch in door Disarm Defeat blue/red   5wi driver rear door harness Parking Lights+ GREEN / WHITE   +   behind fuse box, lower harness Parking Lights- GREEN/ orange   -   headlight switch Hazards same as turn signals        Turn Signal(L) GREEN/ blue   +   steering column Turn Signal(R) GREEN/ YELLOW   +   steering column Door Trigger GREEN/ red   -   behind fuse box, lower harness Dome Supervision use door trigger        Trunk/Hatch Pin GREEN/ black   -   light in trunk Notes: On vehicles with factory alarm, the trunk pin is BROWN / blue (-) in the 16 pin plug at the ETACS ECU. The ETACS (Electronic Timer Alarm Control System) ECU is attached to the fuse box in the driver kick panel. Hood Pin brown   -   16 pin plug at ETACS ECU Notes: The ETACS (Electronic Timer Alarm Control System) ECU is attached to the fuse box in the driver kick panel. Trunk/Hatch Release N/A        Power Sliding Door N/A        Factory Alarm Arm yellow   -   16 pin plug at ETACS ECU Notes: The ETACS (Electronic Timer Alarm Control System) ECU is attached to the fuse box in the driver kick panel. Factory Alarm Disarm yellow/white   -   16 pin plug at ETACS ECU Notes: The ETACS (Electronic Timer Alarm Control System) ECU is attached to the fuse box in the driver kick panel. Disarm No Unlock see factory alarm disarm        Tachometer white   ac   ignition coil pack Horn Trigger GREEN/ red to lt. green   -   steering column Notes: The horn trigger functions only with the blue/white second accessory wire energized. Memory Seat 1 N/A        Memory Seat 2 N/A        Memory Seat 3 N/A        Interface Module: Category: Immobilizer Bypass Required: No Type: N/A Part #: N/A Notes:        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.

thanks a lot

You are more than welcome.Be careful whose advice you buy, but be patient with those who supply it.