the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

need info on 1998 plymouth remote wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
rodlyz 
Member - Posts: 1
Member spacespace
Joined: September 07, 2005
Location: Canada
Posted: September 07, 2005 at 9:44 PM / IP Logged  
need info on 1998 plymouth breeze remote start wiring particularly on the door lock/unlock wiring...
chungo 
Copper - Posts: 135
Copper spacespace
Joined: December 31, 2003
Location: United States
Posted: September 07, 2005 at 9:50 PM / IP Logged  
12volts red, pink/black   +  ignition harness
Notes: When doing remote start red should not be used for main power. Use pink/black.
Starter yellow   +  ignition harness
Second Starter     
Ignition dark blue   +  ignition harness
Second Ignition GREEN/ red   +  ignition harness
Third Ignition     
Accessory blk/orn & blk/wht   +  ignition harness
Second Accessory     
Keysense     
Power Lock WHITE/ green   +  rear of fuse box under dash
Notes: Use positive (+) trigger thru a 620 ohm resistor to lock, and a positive (+) trigger thru a 2.7K ohm resistor to unlock. Must use relays.
Power Unlock same wire    
Lock Motor ORANGE / black   +  drivers kick panel
Unlock Motor blue/white   +  drivers kick panel
Parking Lights+ BLACK / YELLOW    dr kick or behind fuse box
Parking Lights-     
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger yellow   -  front of fusebox
Notes: In a three (3) pin connector near the door jam.
Dome Supervision     
Trunk/Hatch Pin tan/black   -  driver kick panel
Hood Pin     
Trunk/Hatch Release BLACK/ white   +  driver kick panel
Power Sliding Door     
Factory Alarm Arm GREEN/ orange   +  kick or BCM
Notes: Lt.GREEN/ orange from drivers door or dk.GREEN/ orange from passenger or catch either at BCM located behind right side dash. Use a positive (+) trigger thru a 940 ohm resistor to arm, and a positive (+) trigger thru a 470 ohm resistor to disarm. Must use relays.
Factory Alarm Disarm same wire    
Disarm No Unlock     
Tachometer BLACK/ gray   AC coil pack
Notes: 6 cylinder signal on the V-6, 2 cylinder signal on the 4 cylinder engine. If BLACK/ gray on V6 causes starter to drag, use any one of the fuel injection wires at injectors at front of engine and set to one cylinder. The injector wire will be the one that IS NOT dk.GREEN/ orange.
Wait to start     
Brake Wire WHITE/ tan   +  at brake switch
Parking Brake     
Horn Trigger BLACK/ red   -  steering column
Memory Seat 1     
Memory Seat 2     
Memory Seat 3     
need info on 1998 plymouth remote wiring -- posted image.
Interface Module:Category:
Immobilizer Bypass
Required:
No
Type:
N/A
Part #: N/A
Notes:
Interface Module:Category:
Door Lock Interface
Required:
Yes
Type:
Multiplex
Part #: 456LW
Notes:

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer