02 Nissan Altima, remote start

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 02 Nissan Altima, remote start (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

jeepwj

Member - Posts: 3

Joined: January 09, 2006

Posted: January 10, 2006 at 8:22 AM / IP Logged

My information says both the Ignition wire and the starter wire in the harness are BLACK/ red. One of the two BLACK/ red wires is thicker diameter than the other. Does anyone know which is which?

Thanks in advance.

2002 Nissan Altima

Item	Wire Color	Polarity	Wire Location
12V	green	+	ignition harness
STARTER	BLACK/ red	+	ignition harness
IGNITION	BLACK/ red	+	ignition harness
ACCESSORY	red	+	ignition harness
SECOND ACCESSORY	none
TACHOMETER	WHITE/ green		ECM behind glove box *4
POWER LOCK	pink *7	-	pin 37 @ BCM by fuse box
POWER UNLOCK	brown *7	-	pin 44 @ BCM by fuse box
PARKING LIGHTS +	RED / blue		driver kick panel
PARKING LIGHTS -	none
DOOR TRIGGER	*2	-	BCM to right of fuse box
HEADLIGHTS	blu (L), RED / yel (R)	+	IPDM E/R *1
WIPERS	blu (L), blu/blk (H)	-	wiper motor
LF WINDOW UP/DN	blu/red - blu/wht	A	driver window switch
RF WINDOW UP/DN	green - yellow *6	A	driver kick panel
LR WINDOW UP/DN	purple - blue	A	driver kick panel
RR WINDOW UP/DN	RED / yel - yel/blk	A	driver kick panel
TRUNK/HATCH PIN	PURPLE / white	-	pin 18 @ BCM by fuse box
HOOD PIN	yellow/black	-	hood pin switch
TRUNK/HATCH RELEASE	RED / blk or blu/red	-	pin 76 @ BCM by fuse box
FACTORY ALARM ARM	pink/blue *3	-	driver switch in door
FACTORY ALARM DISARM	WHITE/ blue *3	-	driver switch in door
HORN TRIGGER	GREEN / WHITE	-	steering column
BRAKE WIRE	RED / green	+	brake pedal switch
LOCK MOTOR	yellow/red		pin 30 @ BCM by fuse box
UNLOCK MOTOR	GREEN / WHITE		pin 23 @ BCM by fuse box
DISARM DEFEAT	GREEN/ red		pin 31 @ BCM by fuse box
DISARM NO UNLOCK	none
DOME SUPERVISION	comes on with unlock
SPEED SENSE	blue / YELLOW *5	8	pin 9 @ instrument cluster
SUN ROOF OPEN/CLOSE	not recommended
SUN ROOF LIMIT	none
LF SPEAKER	blu/wht - blu/red		radio or amp under rear deck
RF SPEAKER	wht/blk - blu/blk		radio or amp under rear deck
LR SPEAKER	grn/yel - blk/yel		radio or amp under rear deck
RR SPEAKER	blue - red		radio or amp under rear deck
RADIO 12V	YELLOW /GREEN	+	radio
RADIO GROUND
RADIO SWITCH	purple	+	radio
RADIO ILLUMINATE	RED / blue	+	radio
POWER ANTENNA	green	+	radio

Notes:	NOTE: This vehicle has an immobilizer system that needs to be bypassed when adding remote start. Use DEI part number 555U. 1 The IPDM E/R (Intelligent Power Distribution Module Engine Room) is under the hood behind the passenger side headlight. 2 The LF door trigger is lt. blue in pin 14, RF door is pink/blue in pin 10, and the LR and RR door is RED / black in pin 11. 3 Meter these wires while turning the key in the driver door key cylinder. These wires will also lock and unlock the doors. Unlock requires a double pulse. 4 On the 4 cylinder vehicles it is in pin 36, and on the 6 cylinder it is in pin 34. Can also go to one of the ignition coils and use the wire that is NOT red or black. 5 If vehicle has the midline audio system or BOSE, the vehicle speed sense is also found at the radio, it is pink. 6 If vehicle has auto up/down on the front passenger window switch then must go into the passenger door and use blue for up and GREEN/ black for down. *7 These wires are only available on vehicle with left front only power window anti-pinch system. On vehicles with left AND right front power window anti-pinch system, use the factory alarm arm and disarm wires for door locks.

KarTuneMan

Platinum - Posts: 7,056

This member has made a donation to the12volt.com. Click here for more info.

This member consistently provides reliable information

Joined: December 14, 2004

Location: Isle Of Man

Posted: January 10, 2006 at 9:32 AM / IP Logged

Ign. is the small one!

jeepwj

Member - Posts: 3

Joined: January 09, 2006

Posted: January 12, 2006 at 3:55 PM / IP Logged

I am installing an Autocommand remote starter with a DEI 556U Bypass. I finished connecting the wires and tested it out. The car just cranks and cranks and cranks but wont start. Any ideas?

jeepwj

Member - Posts: 3

Joined: January 09, 2006

Posted: January 13, 2006 at 12:41 PM / IP Logged

Hi, I have a 2002 Nissan Altima and when I remote start it the car starts and runs for 10 seconds or so then shuts off. If i put my key in the ignition and turn it to Run during these ten seconds it will remain running. I do not have a tach wire hooked up. I am using an autocommand remote starter and a DEI 556U Bypass. The bypass wires are connected as follows. Red- 12v Black- ground Blue- Status Output from Remote start module.

Any Ideas? Should I be looking at the bypass or something else?

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

02 Nissan Altima, remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.