1995 Nissan 240s
Welcome Guest :)
sclinton
Member -
Posts: 4
Joined: May 25, 2002
Location: United States
Posted: May 25, 2002 at 12:55 PM / IP Logged
I am going to install an alarm on a 240sx and requesting the diagram
Steven C.
Velocity Motors
Moderator -
Posts: 12,488
Joined: March 08, 2002
Location: Manitoba, Canada
Posted: May 26, 2002 at 1:44 AM / IP Logged
Remote Starter Wiring Colors and Notes |
Function | | | Vehicle Color | Location |
Start: | | | BLACK / YELLOW | IGNITION SWITCH HARNESS |
Ignition #1: | | | BLACK/ RED | IGNITION SWITCH HARNESS |
Ignition #2: | | | WHITE | IGNITION SWITCH HARNESS |
Ignition #3: | | | N/A | |
Accessory: | | | WHITE/ BLUE | IGNITION SWITCH HARNESS |
Brake Light: | | | RED / GREEN (+) | SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | | | YELLOW/RED | PIN 3 AT ECCS * |
Parking Lights: | | | RED / BLUE | (+) AT HEADLIGHT SWITCH |
Headlights: | | | SEE NOTES BELOW | ** |
OEM Alarm Disarm: | | | GREEN/ YELLOW (-) | SAME CONNECTOR AS DOORLOCKS |
OEM Alarm Arm: | | | N/A | |
Diesel Glow Plug: | | | | |
Clutch Bypass Wire: | | | | |
Notes: | | * Electronic Concentrated Control System (ECCS) Module Located In Pasenger Kick Panel. Pin #2 Is Also YELLOW/RED Tach Wire. These Wires Are On Short Side Of Connector Near Center Bolt. LT. GREEN/ BLUE At Distributor Is High Signal. ** This Vehicle Is Equipped With Two Start Wires. Both Must Be Powered In Order For Vehicle To Start When Engine Is Cold; |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | | Vehicle Color | Location |
Constant +12 Volts: | | | WHITE | IGNITION SWITCH HARN.(WHT/RED FOUND) |
Starter Kill: | | | BLACK / YELLOW | IGNITION SWITCH HARNESS |
Ignition +12 Volts: | | | BLACK/ RED | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | | RED / WHITE | (-) DRIVER KICK PANEL *** |
OEM Horn: | | | GREEN / WHITE (-) | STEERING COLUMN HARNESS OR AT RELAY |
Power Lock: | | | LIGHT GREEN / WHITE | @ WHITE 12 PIN CONN. IN DR. KICK **** |
Power Unlock: | | | BROWN / RED | @ WHITE 12 PIN CONN. IN DR. KICK **** |
Trunk Release: | | | N/A | |
Alarm Input Wire: | | | RED / WHITE | (-) DRIVER KICK PANEL *** |
Notes: | | *** SE Models Are Diode Isolated. Wire In Bottom Row Of Main Body Harness Conn. In Driver Kick Panel. Proper Wire On Base Model Is BLUE. **** Negative Pulse Door Lock . |
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
sclinton
Member -
Posts: 4
Joined: May 25, 2002
Location: United States
Posted: May 28, 2002 at 8:15 AM / IP Logged
Thanks a Lot This is going to be my first install on a 240sx !!!!
Steven C.
Velocity Motors
Moderator -
Posts: 12,488
Joined: March 08, 2002
Location: Manitoba, Canada
Posted: May 28, 2002 at 9:51 AM / IP Logged
Good luck 
If you need any more help just post your requests.
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Follow the12volt.com
Monday, May 20, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
Printable version
